Search results

  1. dimitrij2k

    Hacking Question Can't install NSP via USB after Trinket Switchme was installed

    Just try these: Start Goldleaf -> USB Mode -> Connect Switch - > Disconnect Switch -> Connect again Try it 2-3 Times, sometime it help.... If not, build in a power switch to your Modchip. So that after Payload the Chip go off.
  2. dimitrij2k

    Hacking Internal Trinket m0 stop working after USB install of NSP

    Im switching between three SD-Cards, all have the same behavior (all Cards are from Sandisk, all different size, all fat32 (32kb)). The Problem can't be here.... My thoughts are, the USB Mode is different. Im not sure if the Trinket react strange or the Switch change the voltage on the...
  3. dimitrij2k

    Hacking Internal Trinket m0 stop working after USB install of NSP

    Okay, I don't found a solution so far for the Problem. Its seems, that the Trinket get Powered over the Data(+) and Data(-) Connection and catch up the USB Data Transfer... But I found a way to prevent this! When i connect USB to PC and fire on Goldtree -> USB Install and Goldleaf is connected...
  4. dimitrij2k

    Hacking Internal Trinket m0 stop working after USB install of NSP

    Hey folks, my internal Trinket m0 (with Fusee-UF2 - THX to mattytrog) is only active, when i press a hidden button behind the backside air-grills (button is on 3v strap) and everything was working like a charm. Switch boot in RCM (autoRCM) and i just hold the button for a second to powering the...
  5. dimitrij2k

    Hacking Question MODCHIP FITTING

    Thank you, for the fast reply & hopefully i am not a big noob in your eyes :blush: start ironing is always a big step for me :unsure: Maybe you could prevent a lot of insecurity for the members in your main software thread, when you build in a "Easy Installation" Guide like: You hate iron...
  6. dimitrij2k

    Hacking Question MODCHIP FITTING

    THX for your work mattytrog :wub: To be clear... 1. Get a brand new Trinket m0 chip 2. put Fusee-UF2 file on it (for ex. "TRINKET_LEGACY3_FUSEE_UF2_V2.UF2") 3. Trinket m0 is done 4. If I already have autoRCM and just want boot direct into CFW, I need the 4-wire Setup 5. put payload.bin on the...
  7. dimitrij2k

    Homebrew RetroArch Switch

    Nope, you don't have to! Just go to the nightly build page and Download the "loader update". That replace the nro file and everything is working :D
General chit-chat
Help Users
  • No one is chatting at the moment.
    OctoAori20 @ OctoAori20: Nice nice-