Search results

  1. N

    Hacking WIP [Trinket] [Rebug] [Others] SWITCHBOOT_UF2 / FUSEE_UF2 modchip software

    I have a weird issue. I think that maybe just my joycon pin is soldered wrong. I am using a trinket m0. Ground is soldered from Gnd to the alternative ground near the switch battery wire. Usb wires are in the normal location. vol+ is soldered to point 0. 3 volt is on the underside of the nand...
  2. N

    Hacking Question How are we going to do this? (Nintendo Switch Lite RCM)

    I actually have a decent idea. If the switch mini really uses the same tegra chip as the OG switch, couldn't we take a vulnerable tegra chip and solder it to a switch mini? Obviously this would be cost prohibitive unless you had access to a hot air station, but in theory, I don't see why it...
  3. N

    Hacking Question How do i fix this?

    I'm sure that gamestop has a place they can send it out to to have the nand restored.... RCM is there for a reason...
  4. N

    Hacking Question How do i fix this?

    he could still boot linux on it right?
  5. N

    Hardware Please help fix sd card corrupt

    I’m about to toss this SD card in the bin. I originally had the card formatted to exFAT. Worked fine until it crashed while running retroarch and Roms started disappearing. So I formatted to fat32, copied over my roms and they were disappearing again. I did a 3x 0 pass with Rufus. Formatted...
  6. N

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    If your ground is bad, right joycon wont connect.
  7. N

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Hey Matty, I'm just letting you know I'm using your latest firmware solution and soldering method. Definitely the best one yet! Cheers!
  8. N

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Thank you for your response! 1) Though I have not resoldered yet, my ground point does not look great, so that may be the source of the weird trinket behavior. 2) yes I can boot into ofw without holding vol+ 3) I will try the other uf2 you suggested. What do you mean by joycon strap? Are you...
  9. N

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Has anyone tested this yet? Curious to see if it will work. I have two issues right now matty. I am using method 2 6 wire setup with trinket m0. Originally I had 3v going to the capacitor shown in post. The trinket would not turn on and was causing power button and joycon to not be...
General chit-chat
Help Users
    K3Nv2 @ K3Nv2: That's one bad nightmare