Search results

  1. MAST3RF0X

    Hardware M92T36 or BQ24193

    Hello there! I'm back with a lot of knowledge but "0" results :-D I've "burned" 4 motherboard without results. However, my problem this time is really strange. Motherboard (I don't know if hackable, but I suppose yes) doesn't power on in any way when pressed Voltage on LCD Power 5v (should...
  2. MAST3RF0X

    Hardware No shorts - Can you help diagnose these switch symptoms?

    Hi! I suppose this is your Switch. (and from Photos I could se your Right Joycon Rail is Jumped for RCM) Remove Battery Cable Connect Cable Power Supply Check Battery Plug Pins (have you 5V for each of both Pin) If Not USB Port Broken or BQ24193 Reinsert Battery Cable (disconnect Charger)...
  3. MAST3RF0X

    Hardware M92T36 or BQ24193

    Yes I've checked. Later I will check again for safe. Also tried to rotate the USB cable without results. Maybe even if I will "swap" with another fuse it will be like a wire...It should not change anything. (but maybe is better to check carefully USB C Port)
  4. MAST3RF0X

    Hacking How to access your Switch's eMMC or microSD card as an USB disk on your PC

    Usually happen when AUTORCM is enabled. Power up you Switch in RCM Mode without inject Payload TegraRCM will find a RCM Device Keep Pressed Power for a while until unit will Power Off Wait a While (10 seconds) Power Up your switch again in RCM Mode You should be able to acces to Boot 0 Boot1...
  5. MAST3RF0X

    Hardware M92T36 or BQ24193

    Resistance Mode 200K Switch 1 : 120 only on the top Switch 2 : 130 on both side Another working Switch : 160 on both side I have here a very old Nintendo Switch Motherboard (Arrived yesterday), maybe a first version. There is no Fuse above USBC. So I was asking my self if in the Switch1 I...
  6. MAST3RF0X

    Hardware M92T36 or BQ24193

    With Diode Mode, Red on ground and black on fuse ( some Pro says this the way to check....don't know why) : 0.4 but the USB side act like is not soldered...no read. Tested the same on Switch 2 and Switch 3 (read below) and 0.4 on both sides of the fuse. Just acquired a third broken Switch 3...
  7. MAST3RF0X

    Hardware M92T36 or BQ24193

    No I've Shorted the USB Pin on Second Switch (where also I believe the M92T36 was shorted / burned because of this ...) The Fuse on first Switch act like a wall. In 5V out 0.2V The Fuse on secondo Switch act like a wire : In 5V out 5V
  8. MAST3RF0X

    Hardware M92T36 or BQ24193

    Yep...edited past post to better understand. So seems Switch 1 have the fuse gone (could be only this??). How I should change / repair it? small cap at Pin9 is working fine (same value as Switch 2, little difference 0.3 but they are quite little different seems) And Switch 2 ... I've read...
  9. MAST3RF0X

    Hardware M92T36 or BQ24193

    ...wait...I've changed Power Supply...measuring Measures Update : Check Images Switch 1 : black fuse just over the USB port is shorted? Switch 2 : just discovered it measure 5V only on one side of USBC (if cabled turned doesn't work) I've tested all Caps in Diode mode on both motherboards...
  10. MAST3RF0X

    Hardware M92T36 or BQ24193

    Here the voltage I can see.. Switch 1 is the working one but not charging Switch 2 is my switch where I shorted out something....(was working, now not anymore) Both works with Hakate Thank you a lot for your support.
  11. MAST3RF0X

    Hardware M92T36 or BQ24193

    Thank you for your fast reply. There is a way to check this chip or the only way is to replace it? Some Update Switch 1 (the one faulty where I've replace cap): Hakate Works, Battery Info says 1000Mah. Start in every way (CFWNand, CFWEemu and Sysnand). The only thing that doesn't work is...
  12. MAST3RF0X

    Hardware M92T36 or BQ24193

    Hi, just need you help :-) Should be simple.... Bought a broken Switch. Find out it was modded by someone with a triket (bed soldered). One cap near battery IC Chip BQ24193 as blowed (as far as i know it was used almost always on the dock...screen was tested ad have areas with shadows because...
  13. MAST3RF0X

    Tutorial How to play Gamecube, PS1, & N64 games from the wiiu gamepad

    I've writed down a Full Guide tutorial for WiiSxR. A lot of time wasted to find information and put togheter! Hope you will find it useful WIISXR ON WIIU : PSX PLAYSTATION EMULATION FULL TUTORIAL GUIDE
  14. MAST3RF0X

    Homebrew Official Retroarch WiiU (wip.)

    For now you should use WiiSxR. Works great with a lot of titles and support DynaRec. PSX PLAYSTATION EMULATOR WIISXR GUIDE TUTORIAL
  15. MAST3RF0X

    Homebrew Official Retroarch WiiU (wip.)

    Some times I must take a look at Clock to understand how many hours I've lost to learn.... However here the results of those days of try,try,try,try,try,try....and try. [TUTORIAL] RETROARCH SCUMMVM FOR NINTENDO WII U WITH GAMEPAD TOUCHSCREEN ENABLED (Italian and English language) Some things I...
  16. MAST3RF0X

    Homebrew Official Retroarch WiiU (wip.)

    Hi, finally after a lot of try copy/paste copy/paste....I've found 1.7.1 works. Time to go to Melee Island... :-)
  17. MAST3RF0X

    Homebrew Official Retroarch WiiU (wip.)

    I need help, please with SCUMMVM. After a lot of reading and trying, lets say I was able to run and play games. However I'm unable to find a way to use touchscreen on gamepad . I'm pretty sure I've missed something... But can't understand where and what. My issue is : scummvm seems to accept...
  18. MAST3RF0X

    Hacking [Tutorial] How to "Undub" Zelda: Breath of the Wild

    Yes, you are right! I must study it and make some video tutorials for others games. Thank you a lot for sharing ideas.
  19. MAST3RF0X

    Hacking [Tutorial] How to "Undub" Zelda: Breath of the Wild

    Did you know that I'm going crazy everytime I play a game without original voices? (Lucky at least Wonderful 101, really a great game, have the switch in the settings menu). However, if inside the folder there is all those voice, I was asking my self if itsn't faster to mod only cos.xml forcing...
  20. MAST3RF0X

    Hacking Which is the best tutorial for Wii U hacking from ZERO?

    I don't think this is the best ... but however is short and explain almost everything. Required a lot of time to edit it. There is a section where is explained how to dump and how to install backup copy. I'm a collector, and can't tollerate to use too much my media.
General chit-chat
Help Users
  • RedColoredStars @ RedColoredStars:
    fuck elvis. lol :P
  • SylverReZ @ SylverReZ:
  • K3Nv2 @ K3Nv2:
    My type c cable is starting to die guess I better order one from my desk
  • RedColoredStars @ RedColoredStars:
    sounds like something Ween would play
     +1
  • ZeroT21 @ ZeroT21:
    And here I thought I was the only one that buy cables in bulk
  • RedColoredStars @ RedColoredStars:
    Nope. Theres two of you! Haha
  • K3Nv2 @ K3Nv2:
    They're so cheap now why not
  • K3Nv2 @ K3Nv2:
    I like the L angle connectors which add more force to it I guess which defeats the point
  • RedColoredStars @ RedColoredStars:
    i only buy new ones when theres a new standard and I have gear that uses it. Otherwise my cables seem to last forever.
  • SylverReZ @ SylverReZ:
    @RedColoredStars, Ween made a song about waving dicks in the wind.
     +1
  • RedColoredStars @ RedColoredStars:
    L angle cables are amazing when needed.
  • RedColoredStars @ RedColoredStars:
    @SylverReZ Yup. Been a longtime fan of Ween. Not a mega-fan by any means but I'm pretty familiar with most of their tunes.
     +1
  • K3Nv2 @ K3Nv2:
    You like the wee
     +1
  • ZeroT21 @ ZeroT21:
    I like electronics that use detachable cables, that way if the cable breaks you can just swap in a new one instead of replacing the whole unit
  • SylverReZ @ SylverReZ:
    @K3Nv2, Ween-er :creep:
  • RedColoredStars @ RedColoredStars:
    they make brown music. lol
     +1
  • K3Nv2 @ K3Nv2:
    Brown note
  • ZeroT21 @ ZeroT21:
    for keyboards, headphones or controllers ,it's a must have
  • K3Nv2 @ K3Nv2:
    Don't know why mice won't get with detachable type c
  • ZeroT21 @ ZeroT21:
    most battery operated mice don't even work anymore if the internal battery dies
  • RedColoredStars @ RedColoredStars:
    the L hdmi adapters work great on my tv and receiver. so much less stress on the ports using them than regular cables. in that instance anyway.
  • K3Nv2 @ K3Nv2:
    A bigger battery could defeat the need for weighted magnets tbf
  • ZeroT21 @ ZeroT21:
    Nowadays pc mice come as light as can be, liked mine with some heft
  • K3Nv2 @ K3Nv2:
    You like holding girth
  • SylverReZ @ SylverReZ:
    @RedColoredStars, I also listen to Beck, some of their songs are fine. Only found out about them through Windows Me; you know, that one operating system nobody ever likes?
    SylverReZ @ SylverReZ: @RedColoredStars, I also listen to Beck, some of their songs are fine. Only found out about them...