Search results

  1. M

    Switch lite picofly problem short long long

    Solution is simple, check pads did you soldered correctly, clean flux use 0.2mm wire for mosfet, other 0.1mm, you can use one mosfet no problem or use flets for apu. make solid pads of mosfet with kapton, mask… gnd wire and vcc used hot glue not to move. Glitching for now is instant no delay...
  2. M

    Hacking Hardware Picofly - a HWFLY switch modchip

    successfully installed Picofly [emoji482] thanks for help Sent from my iPhone using Tapatalk Pro
  3. M

    Switch lite picofly problem short long long

    what have you done to solve issue? Sent from my iPhone using Tapatalk Pro
  4. M

    Switch lite picofly problem short long long

    i removed wires and chip, will try with 0.2wire with insulation, looking to find, buy… hope in few days Sent from my iPhone using Tapatalk Pro
  5. M

    Hacking Hardware Picofly - a HWFLY switch modchip

    fw 2.73 showing debug errors, now i installed new chip and new wires location, error green green Long, real glitch hack as on xbox 360 you should watch where your wires go…. Sent from my iPhone using Tapatalk Pro
  6. M

    Hacking Hardware Picofly - a HWFLY switch modchip

    cmd and data, mistake “one each on CMD and DAT0, like below, for a total of 94 ohms on each line” Sent from my iPhone using Tapatalk Pro
  7. M

    Hacking Hardware Picofly - a HWFLY switch modchip

    nintendo switch lite, removed chip, working normal. checked points all Ok not used diode mode to check. used 0.1wire, after i used 2wires for data0, clk etc. gnd awg30 wire…. same soldered sda and scl no lack. Never tries presing reset after screen show , you mean shortin 1-2pins on side? on...
  8. M

    Hacking Hardware Picofly - a HWFLY switch modchip

    picofly 2.73 i have blue, short green, long green long green. anyone know what this code could be? i changed RPI 2040 zero(have only 2), changed wires, re solidered few times. i have used 0.1mm wires, then dubule 0.2 wire tried 2 mosfets, 1mosfet- same tried 2, 47 Ohm resistor on data and...
  9. M

    Switch lite picofly problem short long long

    do you know what this code could be? i changed RPI, changed wires, re solidered few times. left to use awg30 kynar wire and try. tried 2 mosfets, 1mosfet- same anybody found solution?
General chit-chat
Help Users
  • No one is chatting at the moment.
    Xdqwerty @ Xdqwerty: See ya see ya later later