Did you manage to get it working again?
Here is a list of error codes I've compiled for the Instinct NX from sthetix's video.
INSTINCT NX ERRORS
FPGA error
Blinking red lights x 7-8 continuously for long time + then nothing (no OFW)
3.3v disconnected
No signal + switch wont turn...
I recently got a 2.50FW from japan using the Buyee website. Just searched for brand new CFI-1000A consoles and asked the some questions for a few of the listing on when it was purchased. The 3.00FW was released on 14 April 21, so if they purchased the console around that date then it should be...
Could be CPU/APU issue?
From these videos they had to reflow to fix it, but im not 100% sure if you have the same issue.
Check out time 7m 40seconds
or
Awesome, thanks!
This works really well.
A bit of a pain to reduce fps for cutscenes, but those are not very common so far so its all good.
Does anyone have a cheat for korok seeds,
eg max them out or not reduce when using them
Thanks, my game plays at 60fps using overclocks but the cutscenes still play fast, (I tested the cutscene at the start of the game under the castle when ganon gets freed).
I updated to version 1.1.0 but still have the same issue.
I tried a few other ones like "cutscene fix" but they dont do...
Does the switch boot to OFW afterwards?
Looks like your switch blinks purple for a bit, then solid white light.
Unfortunatly, im not too sure what that error is :(
Here is a list of error codes I've compiled for the Instinct NX from sthetix's video.
INSTINCT NX ERRORS
FPGA error...
I'm not tooo sure about other people, but my switches with the B points gettig OL seems to be working fine.
What value were you getting on your B point before you did any work on the switch?
My white instinct NX was giving me issues but when i did a swap with the black one it worked fine
Maybe...
Aww man, sorry to hear that, didnt think that you would try to remove the flex cable :'(
Yea I try to be quick soldering those points so as to not put too much heat on them as they can move around/get damaged.
Have you tried booting your switch without the capacitor?
Do you have the white or...
I have installed mod chips on 2 switches. (both working fine)
Neither of mine shows the B point with 2.9v that other people have.
I get "OL" for my B point
I have seen some youtubers doing the install and some of them also get a "OL" value for the B point.
Check if you are getting "0" or "OL"...
although i ended up accidentally changing my nand with no way of going back bc i didn't know you needed a gamecube controller to restore it (i have a wii minus/1.1, which doesn't have gamecube controller support)
and if i find the sd card i have my NAND backed up on, i can not only restore the NAND if i solder the right part in, but i can also put my NAND on dolphin, then i can play dolphin online, like PMEX Remix or MKWii Riibalanced