Search results

  1. MastahXd

    Hardware GBA Backlight! (AGB-001)

    As far as I know all the screens from the SP have the same connectors and pinouts. They differ in front-lit/back-lit, and also A or B type which I actually don't get (propably the amount of "fat" traces).
  2. MastahXd

    Hardware GBA Backlight! (AGB-001)

    Great job!
  3. MastahXd

    Hardware GBA Backlight! (AGB-001)

    If I get it right, you used two ribbon cables together. You are supposed to use only one. Use the one that fits motherboard's socket.
  4. MastahXd

    Hardware GBA Backlight! (AGB-001)

    Hi, try using the C35 or C36 cap from the other motherboard (soldering skills required, use lots of flux - it's not conductive so you may even leave it after on the board, use needlenose pliers - these are quite indispensable). These two caps are propably same specs. It's usually the case in the...
  5. MastahXd

    Hardware GBA Backlight! (AGB-001)

    I bought exactly from this supplier, quality of the screen is about 8/10. Works just fine, image lokks really nice. Here is the screen with ribbon (screens can be distinguished by a ribbon cable, I think it's type A, but you need to confirm that):
  6. MastahXd

    Hardware GBA Backlight! (AGB-001)

    Should be more like 10 min tops, anyway it's quite a good job you made because it works ;-P. Next time I recommend you use some soldering flux (the cheaper the better if not a proffesional). While soldering put some flux on your soldering points, add some tin with lead in it (SnPb) and add some...
  7. MastahXd

    Hardware GBA Backlight! (AGB-001)

    EpicPal try aliexpress and glass lenses available there 5pcs/lot 10USD/lot. Good quality, not overpriced. If the picture in the auction says advance only don't worry, they photoshop logos out. Check previous pages for photos.
  8. MastahXd

    Hardware GBA Backlight! (AGB-001)

    I've never seen a tutorial telling you to remove ANY plastic from the back of the case as ker suggested. Try removing all the rubber strips, install and position the display properly in the front case. Then it shouldn't interfere with the back of the case. In mine it makes no contact at all, as...
  9. MastahXd

    Hardware GBA Backlight! (AGB-001)

    Bahustard, I belive that this is the correct REVC test point (marked in yellow):
  10. MastahXd

    Hardware GBA Backlight! (AGB-001)

    Hi, KB89 the lenses i bought were also saying Advance only in the auction picture but came like that:Sorry for the picture's quality ;-P
  11. MastahXd

    Hardware GBA Backlight! (AGB-001)

    As this is my first post on this forum, I'd like to say hello to everyone. Using some of the information from this thread I recently completed the installation of mine backlit screen I ordered from Aliexpress As you all can see my workspace is on a kitchen counter, but still i managed to...
General chit-chat
Help Users
  • No one is chatting at the moment.
    SylverReZ @ SylverReZ: But I bet that would be more for a flashcart than a consumer repro board. +1