Recent content by xiran64

  1. X

    Tutorial PS5 Exploit Guide

    Disk drive modification works with fw 13.00?
  2. X

    Tutorial PS5 Exploit Guide

    Hi to all! i've 2 ps5 digital, one with 10.40 and the other in 11.30. In 10.40, tried netflix n hack But in step to generate keys to run ws.py openssl... command didn't be recognized... so, ws.py give errrno 2...
  3. X

    Nintendo Switch OLED with a green background instead of dark sides

    Llevalo a pearfix
  4. X

    Xbox Series X Testpoints TP readings

    There are various capacitors in that line, so before to doubt from southbridge (more difficult), will check all capacitors associates at that line (17+ capacitors...)
  5. X

    Xbox Series X Testpoints TP readings

    Ok, i´ll try UPDATE: With ic 8 pins desoldered: This are the new voltages, tp8 descend, tp10 grow 0.15v UPDATE: 025mV diode mode, and 19.6 ohms
  6. X

    Xbox Series X Testpoints TP readings

    The xbox didn´t power on (pressing power button or eject button in sub board), no beep, connect control xbox one to try to power on (all sub boards connected), without luck... Voltages are the same in your table, but TP8 resistor and diode are very low (not short), diode mode 21mV and resistence...
  7. X

    Xbox Series X Testpoints TP readings

    Hi to all! I've an xbox series x that didn´t power on. I´ve this readings: TP8 is a low impedance, initially, have a 1v1 regulator burned, changed it, from another working, only for test, it have 1v1 output, if i...
  8. X

    Xbox series x daughterboard didn´t power on

    Hi to all! I´ve an xbox series x, that don´t power on. Have another, with diferent daughterboard, and only tested daughterboard, to check if powers on. Good daughterboard, powers on (don´t care if in some seconds power off). But bad daughterboard, didn't power on Checked, and have ic regulator...
  9. X

    Ps5 aurt error 80801101

    Not yet, APU reball or change it, is needed
  10. X

    PSU ps5 digital burn

    Changed qn4106, with same result, clip sound 1772842632 Solved! Bad balance in an optocoupler
  11. X

    Xbox series x don´t power on

    Ok, thx! UPDATE: SB didn´t response... Durango post don´t send something, detected in app xbox postcode, but no text... UPDATE2: SB it´s now communicating, after finding fail in mainboard, now receive data in postcode. It´s rare, now, it have no comunication with MB (fat ribbon), but secondary...
  12. X

    Xbox series x don´t power on

    Oh, I had completely forgotten about the Durango post. There are two of them; one doesn't turn on, and the other turns on and then off. I did a test where the one that turns on and off, if I only supply 12V to the sub-board, should beep, light up the LED, and then turn off. The second one...
  13. X

    Xbox series x don´t power on

    Thx for answer testerfan! I´ve solder the ic, from another xbox series x that don´t power on, the same ic, but yet it power on/off... For some reason it burned, maybe it was the reflect of something more, did you have any clue, or where can i check? Thx again!
  14. X

    Xbox series x don´t power on

    Hi to all! I have one xbox series x, that don´t power on. Open it, and check an ic (u34) burned. It´s an 8 pin, and 2D=E2H mark, somebody know wich ic are? Thx in advice!
  15. X

    PSU ps5 digital burn

    Thx for answer thesjaakspoiler! Yes, psu meassure apart, 12.15v, ps5 tested with cpu psu, runs without problem UPDATE: Have two psu, same problem, i´ve can see, the mosfet in red circle, are in short, in both psu, so, need to investigate that Checked schotty diode, are good or not? Google...
See more