Recent content by VictorBan

  1. VictorBan

    Hardware Homebrew If a mosfet is connected properly, but the CLK, RST, CMD or DAT0 aren’t, should the switch boot normally or not?

    Yes I know, but I just wanted to know if it should still boot to ofw.
  2. VictorBan

    Hardware Homebrew If a mosfet is connected properly, but the CLK, RST, CMD or DAT0 aren’t, should the switch boot normally or not?

    I am trying to install picofly on my switch lite and I’m trying to install the mosfet on the rear of the console, but I don’t have the resistors rn so I didn’t connect CLK, CMD and DAT0. Though, my Switch still boots normally when I power it on, while the RP2040 shows the error for the not...
  3. VictorBan

    Hardware Got a broken nintendo Switch Lite, how should I proceed regarding it’s repair.

    Gotcha, will update tomorrow once I have the IPA, then proceed with the install of the capacitors. 1692122014 Also, can I use a 1uf 10v capacitor to replace the one near the 3.3v point circled in the picture? 1692131468 Or perhaps someone knows it’s value. 1692177945 Update: Cleaned the board...
  4. VictorBan

    Hardware Got a broken nintendo Switch Lite, how should I proceed regarding it’s repair.

    Found some isopropyl alcohol 90% at a store near me, is it any good? (Isopropyl technical alcohol 90%, for cleaning and diluting varnishes, 0.5 L, Dragon)
  5. VictorBan

    Hardware Got a broken nintendo Switch Lite, how should I proceed regarding it’s repair.

    Other than flux, I doubt it.
  6. VictorBan

    Hardware Got a broken nintendo Switch Lite, how should I proceed regarding it’s repair.

    Let me begin by saying that this switch is absolutely horrifying. Nothing is in it’s place, and I see a lot of capacitors missing. I’m going tomorrow to pick up some 1uf 10v capacitors and some isopropyl alcohol, then clean this thing until it looks brand new and replace the missing cpu...
  7. VictorBan

    Picofly install on Switch Lite says CMD error

    I dont have any other cable at the moment. Is there another CMD point I could try soldering to?
  8. VictorBan

    Picofly install on Switch Lite says CMD error

    Thank you. I only have a thick head for my soldering iron and it’s hard to use it, but I’ve tried my best. I’ll try in a second to fix everything you just say, and improvise a slimmer (I hope this word exists) head for my iron. Will get back to you. 1692045809 Is this any better? 1692045886...
  9. VictorBan

    Picofly install on Switch Lite says CMD error

    I know I don’t have the resistors, but people reported it working even without those. What seems to be the problem, I don’t see any problem in my soldering. (Yes I know the cables are thick but they are the only ones I have atm.) 1692010789 Should’ve mentioned the RP2040 sends the error *= (CMD...
See more