Recent content by Tailsy
-
Hacking Hardware McFly - an RP2040 board compatible with Picofly
@Saliciae I just spotted a different issue with your board, you seem to use microvias or just very small, typical vias. I see also vias in pads. This stuff is very expensive to produce and out of question for hobby boards. Min via drill size for JLCPCB is 0.3mm with 0.6mm diameter. You really...- Tailsy
- Post #59
- Forum: Nintendo Switch
-
Hacking Hardware McFly - an RP2040 board compatible with Picofly
If the jumper can be covered during programming, you can consider saving even more space by putting the 5-pin connector inside of the USB board, which would make it rectangle and look less separated from the main board. But this is only when we consider protruding connector as non-important.- Tailsy
- Post #51
- Forum: Nintendo Switch
-
Hacking Hardware McFly - an RP2040 board compatible with Picofly
5 mils=0.127mm is less than required JLCPCB 0.2mm Trace to Outline limit, and much less that 0.4mm if you need v-cuts (for panelizing later). If it made it through, it's probably because you've chosen expensive ENIG finish, so they're less forgiving. I would definitely fix that, even though it's...- Tailsy
- Post #49
- Forum: Nintendo Switch
-
Hacking Hardware McFly - an RP2040 board compatible with Picofly
@Saliciae Thanks for sharing the board, seems very nice. Looking at it I've got 2 concerns (which even encouraged me to register, so hello :P). First concern is clearance to board outlines. It seems to me that at least 3 traces (2 on the left of flash chip, one around xtal) seem to be very close...- Tailsy
- Post #43
- Forum: Nintendo Switch
