Recent content by Storm234

  1. S

    Hardware Black Screen after "Nintendo" Logo at Boot, HELP

    Thanks a lot. Was able to sort this out. Looks like the problem was a missing capacitor on the nand module. Once soldered back. All is working. Luckily I had an extra Emmc module. Would be great to know the capacitor data or value to revive the other module
  2. S

    Hardware Black Screen after "Nintendo" Logo at Boot, HELP

    I have a similar problem. Bought a brand new switch. Installed sx core booted into sx loader and created a emunand Then tried to boot into cfw ... got nintendo logo and black screen right after. Tried to boot into ofw ... same thing. I am stuck with this one. If you can please help...
  3. S

    Hacking SX Core - cannot boot to CFW or OFW - blackscreen

    Hi all, I have the same issue. Installed sx core chip on switch v2. This is my 3rd chip but this time it was unsuccessful. I got to the sx boot, dumped the nand and all went fine. Then I tried to boot into cfw, nintendo logo appeared for 2 sec and then black screen. Tried to boot to ofw ...
  4. S

    Tutorial Trinket Internal Install.

    I have soldered the strap to the 2 small point hidden under the flex cable and connected to point 3. As seen in the tut. I assume that this should have allow the trinket to ground the joycon pin durming power up. So no auto rcm is required. Am I missing anything? Finally I figured that out. The...
  5. S

    Tutorial Trinket Internal Install.

    I used the part one of perma cfw and part 2 of fusee Tried 3 times ... no change
  6. S

    Tutorial Trinket Internal Install.

    Hi all, This is my 1st time hacking a Nintendo console. Had great experience with XB. I tried to install the trinket as described in the tut. The problem that I m having is that it doesnt wake up when the switch is turned on. When I press the reset switch the lights on the trinket turn on. I can...
See more