I've replicated my mistake. I think my mistake was scratching through the square pad on the cpu that is an alternative point for source on the mosfet. damn. Both units bluescreened. Crazy thing is that picofly boots.
Oh, you mean power issues that prevent the sd card from being read?
measured 1.8 vs on one of the test points. My guess is no 3.2 v. Any way I could rig this by feeding it 3.2v from elsewhere?
Got myself a V1. Seller told me it was patched. Was really pumped to put our beloved picofly on it. Checked the serial. Damn thing is unpatched. LOL. So gonna do a Switch lite instead.
safer to use thinner wires IMO. You run the risk of tugging the wire in some installs. With a thicker wire you could rip a terminal or worse a capacitor.
How to do this? doesn't RP2040 clear the bootloader when we press reset then boot button. I mean drive is always empty when we do this. How to enter boot upload mode without erasing the previously flashed UF2 file? Thanks
I tried downloading with 9 burned fuses to run Atmosphere 0.8.3. Switch boots up but I get an error with Atmosphere. Note that I used firmware 6.2.0-1.7