Recent content by serg_serg

  1. S

    Nintendo Switch v2 unsuccesful chiping

    1. cpu is heated. Picture sometimes appears for a moment. then heating and a black screen. Sometimes immediately heating and a black screen. Cpu caps has 1.8V and 0.86V. no short circuit. 11/11/56/150 ohm. It is being warmed up. 2. Caps on the APU TEgra X1 are NOT pass-through and, by all...
  2. S

    Nintendo Switch v2 unsuccesful chiping

    by the way, console sometimes start, i see logo, 1second and hot cpu&black screen... try to solder / desolder this 3 capacitors - no result. i thnk switch can start without them mayby thiis cpu problem&
  3. S

    Nintendo Switch v2 unsuccesful chiping

    i checked resistance on these 2 capaitors (they need ti soldered to hwfly) - 12 ohm/ i think this is cpu power/ checked voltage-0.86v think there is no short circuit. another group capacitors has 56 ohm and 150 ohm
  4. S

    Nintendo Switch v2 unsuccesful chiping

    continue story... after stand without power . began to start turned on the cooling. even with it it gets very hot. cooler to the full and hangs in the menu. any ideas?
  5. S

    Nintendo Switch v2 unsuccesful chiping

    Hello everyone! Sorry for my bad english Have a problem. Switch v2 didnt start after insalling hwfly/ found 3 broken capacitors replaced them with 1uF console also didnt start if it stays for a long time without power, plug in the charging. the charge icon lights up. for a second and there...
  6. S

    Hacking Brick at dumping rawnand process

    Hello! I need help I wanted to upgrade. Began to take a dump It seemed to be filmed and hung - the "close" button does not work Hold the button on - it turned off and no longer turns on I managed to dump rawnand.bin only The firmware was at the time of the brick: 9.2.0 I have boot0, boot1...
See more