Recent content by Sanickpk

  1. Sanickpk

    PS5 UART commands

    Hello everyone! PS5 edm 010 after the PS logo reboots and asks to reinstall the software, the installation goes without errors and again the PS logo and reboot. There are no errors on UART. What could be the problem? OK 00000000:3A $$ [MANU] UART CMD READY:36 errlog 0:DB errlog 0:DB OK 00000000...
  2. Sanickpk

    PS5 displays logo then shot down!

    I have a console on the edm-010 board with exactly the same problem, after the PS5 logo, the console turns off and goes into safe mode again, where it asks to install the software again, the installation goes without errors! I changed the SSD controller, then re-soldered all 6 SSD cans, no...
  3. Sanickpk

    ps5 edm-010 eternal reboot in safe mode

    and so I got the safe mode to start, I can reinstall the firmware and it will install without errors, but after everything is installed the ps icon appears and says console storage repair 20%, then suddenly 100% and the message something went wrong! What was done: first I replaced the ssd...
  4. Sanickpk

    Hacking Hardware Picofly - a HWFLY switch modchip

    Help identify the component and its value. switch rev.1 mosfet burned out and took it with me
  5. Sanickpk

    meaning of components near the ssd controller

    Yes, the resistance of the resistors will be enough for me! Thanks in advance friend!!!
  6. Sanickpk

    meaning of components near the ssd controller

    I received the board with components removed at this location
  7. Sanickpk

    meaning of components near the ssd controller

    Can anyone at least measure the resistor values?
  8. Sanickpk

    meaning of components near the ssd controller

    Can anyone tell me the meanings of these components near the ssd controller?
  9. Sanickpk

    ps5 edm-010 eternal reboot in safe mode

    Here is the video, and at that moment when I forgot to turn off the auto mode on the tester and it switched to beep mode, after that the 2.5V voltage disappeared and I was able to enter safe mode
  10. Sanickpk

    ps5 edm-010 eternal reboot in safe mode

    I managed to enter the recovery menu by accidentally shorting this cap with a multimeter while checking the voltage, in the photo I had already unsoldered them and they turned out to be fine (small at 1uf, large at 10uf)I think that the chip responsible for the ssd or the ssd banks themselves...
  11. Sanickpk

    ps5 edm-010 eternal reboot in safe mode

    They cannot enter this mode; when you press the ps button, the console restarts to the same screen 1696073231 after turning on the console, 5-10 seconds later heating occurs on the RAM banks
  12. Sanickpk

    ps5 edm-010 eternal reboot in safe mode

    ps5 turns on and immediately asks to connect the dualsens via wire and press PS, and when you press PS the console reboots to the same screen, and I noticed that the RAM banks immediately heat up. What could be the problem? All main supplies 12.5, 3.3 V are present.
See more