Recent content by SafarGet

  1. S

    PS5 Slim EDM-040 error 80D004FD

    Thank you. I tested this dump as well, but unfortunately the WiFi still does not appear and the same issue remains. After the PlayStation logo, the screen goes black exactly like before. Most EDM-040 boards come with the J20H104 and use only a 3.3V power rail. However, some rarer boards come...
  2. S

    PS5 Slim EDM-040 error 80D004FD

    The update I performed was firmware version 10.01. I also measured pin 13 (CEC) on the HDMI port: - Diode mode reading: 695
  3. S

    PS5 Slim EDM-040 error 80D004FD

    Thank you for following up and replying every time. I flashed the BIOS using both dumps you attached, but the WiFi network still does not appear. Also, I replaced the HDMI port, but the issue is still the same. I measured Pin 13 on the HDMI port, and it reads 1.3V. At this point, I think the...
  4. S

    PS5 Slim EDM-040 error 80D004FD

    After changing the board serial and matching the number on the motherboard with the BIOS dump, and also updating the number on the WiFi/BT module: Now all USB Type-C ports are detected and working, and the console updated successfully. However, the same issue still remains — after the...
  5. S

    PS5 Slim EDM-040 error 80D004FD

    After replacing the WiFi/BT module, the console now displays an image, but it is unstable and flickering. Also, only one of the front USB ports is working — the other front port is not working, and the rear USB port is also not functioning. Additionally, in recovery mode, no WiFi networks are...
  6. S

    PS5 Slim EDM-040 error 80D004FD

    I checked all the resistances around the HDMI IC, and they are all correct and match exactly the reference image I will attach. After that, I thoroughly cleaned the surrounding area. The console then powered on, and the PlayStation logo appeared at 480p resolution, but shortly after that the...
  7. S

    PS5 Slim EDM-040 error 80D004FD

    Hi, The console originally had a minor issue, but unfortunately a technician caused multiple short circuits in different areas of the board. At this point, I believe the problem has been mostly narrowed down. Based on the image you provided, all resistance readings appear normal and healthy...
  8. S

    PS5 Slim EDM-040 error 80D004FD

    I replaced the WiFi chip with J20H100, and now I’m getting a new error. The tool reports an HDMI IC problem or data line short / power failure. I checked the HDMI IC and there is no short on it. On the power supply, the board initially draws around 450 mA 6 second, then it starts fluctuating...
  9. S

    PS5 Slim EDM-040 error 80D004FD

    [You are right. I found that there are two versions of the EDM-040 board. Most of them use the newer setup with J20H104 and a single 3.3V rail. But there is a rare version that uses the older setup with J20H100.
  10. S

    PS5 Slim EDM-040 error 80D004FD

    Under the J20H104 area, I measure 3.3V on the capacitors, which indicates that the WiFi rail is 3.3V. So it seems the board is actually using a single 3.3V supply for the WiFi section. Please confirm if J20H104 is still the correct chip for this board. My board is EDM-040.
  11. S

    PS5 Slim EDM-040 error 80D004FD

    , I’ve attached photos showing the voltage readings in the two DC-to-DC areas. When I plug the device into power, it draws around 225 for about 7 seconds, then drops back to only 8. I’ve also attached an image with the measurements for reference.
  12. S

    PS5 Slim EDM-040 error 80D004FD

    The WiFi module I have is J20H104, not J20H100. Also, I don’t have the original BIOS — I believe the current one may be from another donor board. Could you please share a picture or highlight the exact components I should check to confirm whether the issue is from that area or not? For example...
  13. S

    PS5 Slim EDM-040 error 80D004FD

    1777580506 I have changed WiFi/BT module But Same the code remain Maybe the issue is caused by an incorrect BIOS. I don’t have the original BIOS — I believe the current one is from another donor board PS5 Slim Here are the main components on the board: * Southbridge: CXD90069GG * WiFi...
  14. S

    PS5 Slim EDM-040 error 80D004FD

    I already replaced the USB IC, but the issue is still the same. What do you think could be the problem now? Could it be: * WiFi/BT IC itself? * Missing pad or broken trace? * Or something else I should check? How I know this Southbridge is work perfect or not. ? Maybe the problem from...
  15. S

    PS5 Slim EDM-040 error 80D004FD

    Thank you for reply No short found , resistance 335 Diode , and 3.3v 1777026507 Found a TLV62090 (WiFi/BT step-down converter) with the following readings: • Pin 3 (PVIN) → 5.0V ✅ normal • Pin 7 (PGND) → 4.6V / Resistance to GND = OL (open) ❌ • Pin 8 (PGND) → Diode mode = 1.180 ❌ • Pin 10...
See more