Recent content by Saebas

  1. S

    Hacking Online and CFW

    You should stop the way you're rolling. If you want to have NSPs while keeping the possibility of going online: use EmuMMC for CFW, keep your sysNAND clean* *you have already installed NSPs on your sysNAND, so to avoid problems you should restore your NAND from a clean backup.
  2. S

    Hacking Question Did I bricked it? Switch won't turn on

    Yes I've tried. It just doesn't boot into RCM mode either. Tegra can't see anything while connected via usb. Just tried holding longer, just in case. Nope. I hope it is a voltage security feature that's making it unable to turn on. I've seen that reconnecting the battery solves it. I'm just...
  3. S

    Hacking RELEASE Firmware Version Inspector - get FW version from NAND dump

    Hi guys. I'm trying to check the firmware of my first backup. I tried using Python 3.7 64bit on windows 10, but I got the same error again and again saying it didn't found the BIS keys. So I tried with Python 32bit, but now it says this: E:\test>python FVI.py [-b=biskeydump64.txt] rawnand.bin...
  4. S

    Hacking Question Did I bricked it? Switch won't turn on

    Hi, A) it was actually full battery before this, so I haven't tried to recharge it. As I would actually prefer it do drain first and then try this. This was just yesterday, so not yet. B) it is not in RCM mode either, I already checked.
  5. S

    Hacking Question Did I bricked it? Switch won't turn on

    Thanks. I will have that in mind.
  6. S

    Hacking Question Did I bricked it? Switch won't turn on

    Hey guys. I had my Switch working on OFW 8.1.0 AMS 0.9.2, using sysnand (last OFW installed without ChoiDujourNX was 6.2) for online and EmuMMC for CFW. Today I launched Hekate (v5.0.1 and Nyx v0.8.1) and selected launch CFW. I was expecting it to run from EmuMMC, and after boot I installed 2...
See more