Recent content by rzkruspe

  1. R

    Hardware Black screen epidemic ?

    Just fixed the other one, the SD reader connector was a bit loose. It too loads emuMMC, and it has Fortnite.
  2. R

    Hardware Black screen epidemic ?

    As said before, I have tried booting into maintenance mode. Without success. And I didn't say the power button doesnt work, I said nothing happens when I press it. And I'm not too sure what your claim is, regarding my talking about HOS and emuMMC. None of the customers tried hacking their...
  3. R

    Hardware Black screen epidemic ?

    Ok so, the one Switch that is both unpatched and loads Hekate without issue (the other one says the card is in 1bit mode), does launch the emuMMC just fine. I can confirm that it has Fortnite on it, with an update pending.
  4. R

    Hardware Black screen epidemic ?

    Well, apparently not. Do i need to recreate the emuMMC -with- the console I'm trying to launch it on ? (I mean that would make sense, but I thought I could gain a little time here x) ) I'll give it a try when I have the time. But how would that help us in this situation ?
  5. R

    Hardware Black screen epidemic ?

    All of them stay on a black screen outside of RCM manipulations. 20s power press, Vol+/- and power, etc. combos yield no result. Two of them do load Hekate, but give a black screen upon loading fusee (though I did not try creating a specific emuMMC partition for either of them, the partition...
  6. R

    Hardware Black screen epidemic ?

    Out of the 3 unpatched ones, 2 of them can take a payload, and Hekate says they have AutoRCM disabled. Side note, the third one might actually have a display related problem.
  7. R

    Hardware Help please, does anyone do hardware repair for switch?

    I could also do that, if you're willing to send it in France.
  8. R

    Hardware Black screen epidemic ?

    Hi all, I currently have a total of 6 Switches to try and fix. They all have more or less the same problem : -They charge just fine (15v 0.5-0.6A) -they don't react to the power button being pressed -they stay on a black screen, without ever showing either logo or battery charge symbol -they...
  9. R

    Hardware Switch not detected by PC, advice needed please.

    The test points by the connector go directly to the connector, that continuity test doesn't tell you much. Do a diode mode measurement on these test points, you should get around 0.8 on both d+ and d-. Also check continuity across the little filter that is near the TPs.
  10. R

    Hardware Nintendo switch - no power - goes to 15V 0.49A direclty

    Hi, I'm bumping this thread too because I have several -patched- switches that exhibit the same behavior. Namely I have a Switch Lite, and 2 regular Switches (serial XKJ4xxxx..), one of them being 4 months new. All 3 of them : -charge at 15v ~0.5a unchanging (indicative of them not...
  11. R

    Hacking Question No RCM detection on a hackable Switch (according to serial) serial)

    Ok, so I decided to desolder the CPU on a donor board in order to confirm that the Data lines run straight to the CPU. And they do. So I guess the USB controller is integrated to the CPU, and the one on our Switch is dead, even though everything else works fine. I think we can close the thread...
  12. R

    Hacking Question No RCM detection on a hackable Switch (according to serial) serial)

    Now a major update. I just fixed my other switch. Don't have the opportunity to test the dock's USBs for now but it is finally detected in RCM, and charging while the system is on. The issue was indeed with the Data lines for USB but not the connector itself. There is a double filter between the...
  13. R

    Hacking Question No RCM detection on a hackable Switch (according to serial) serial)

    I have minor news My other switch, the one that is supposedly patched and with which the USB ports don't work when docked. It's actually a XAJ7001xxx. So it shouldn't be patched, but it exhibits the same issues as my friend's. So I have something new to work on.
  14. R

    Hacking Question No RCM detection on a hackable Switch (according to serial) serial)

    It isn't recognized on my phone either (even though my personal switch is). I just noticed something else, when the console is docked, the USB ports on the dock are turned off, I saw that with a USB ampmeter. I have another (patched) console that does the same thing, and I never managed to fix it.
  15. R

    Hacking Question No RCM detection on a hackable Switch (according to serial) serial)

    Yes, it is the same as the one on the chassis. I'll try that and keep you updated.
See more