Recent content by MrBabelPhish

  1. MrBabelPhish

    eMMC cover breaks dat0 connection

    That is all correct, though I even struggle to get the C pad on the modchip to even read 0.77V consistently (without shield). I'm getting no ground shorts at all, and the unit is completely disconnected from battery. I've disconnected all other cables from the mod chip, and now the 1.5V is...
  2. MrBabelPhish

    eMMC cover breaks dat0 connection

    Sweet, I've just ordered them, I can confirm its the wire, can't get a reliable connection with it to save my life
  3. MrBabelPhish

    eMMC cover breaks dat0 connection

    Nope, no dodgy continuities anywhere. I think it must be a cable issue, but I'm getting 0.77V when measuring from the C point on the flex PCB, but 1.5V when measuring on the matching C pad on the other end of the cable, but still somehow get continuity across the cable :wacko:
  4. MrBabelPhish

    eMMC cover breaks dat0 connection

    well I've done that, reattached the flexPCB and reconnected but I seem to still be struggling with the same problem. After more experimenting It turns out 1.5V is actually also the reading between C and GND without anything connected, so it seems the 0.77V is being overridden with that, maybe...
  5. MrBabelPhish

    eMMC cover breaks dat0 connection

    I'll give that a try and report back, though I don't have any solder mask on me, a bit of kapton should block it the same right?
  6. MrBabelPhish

    eMMC cover breaks dat0 connection

    The wire is 30AWG, quite thick but not massively so. I did also think this, but I tried bending the corner of the shield up to avoid any pressure on the wire and it still happens. plus then I Imagine it would short to the grounding of the shield, but it doesn't have continuity to ground, just...
  7. MrBabelPhish

    eMMC cover breaks dat0 connection

    Thought the corner as advised by sthetix
  8. MrBabelPhish

    eMMC cover breaks dat0 connection

    had a (self) modded switch with a Hwfly v5 chip for over a year now and has been working fine until last week, it ran out of battery and won't turn on. purple flashing then solid red. I cracked it open and it seems the dat0 connection has given up, getting 1.5v on diode mode. However this is...
See more