Recent content by Mojoswagger1980

  1. Mojoswagger1980

    Can a mig switch theoretically be used as an SD card reader?

    1733414166 Nope . I understand what you mean but no the device will not see the game card reader as storage . With team executers firmware on it, it mounts as a rom and without the firmware it, the device acts like its not inserted at all .
  2. Mojoswagger1980

    Problem getting pc to recognise switch

    Go into device manager and check if the APX driver is installed correctly on your pc . Its usually due to Windows incorrectly installing the driver . People reccomend an app called Zadig, but i just uninstalled the driver in device manager and then manually told it to install the right one, but...
  3. Mojoswagger1980

    Nintendo switch won't boot rcm etc

    What are you using to inject the payload ? Had a similar problem and couldn't for the life of me figure out what I was doing wrong . I was using TegraRCMgui because i had used it initially but i got notta . Since i litterally couldn't think of anything else i tried a different payload injector...
  4. Mojoswagger1980

    Switch lite backlight and modding

    You might try inspecting the daughter board that houses the left joycon inputs to ensure that it isnt damaged . It also houses the components for screen backlighting on the switch lite . Found that out when my Left analog decided it wouldn't register vertical movement anymore and decided to...
  5. Mojoswagger1980

    Any Idea where to find short - next debugging Steps for Switch Lite black screen

    Did you swap out/repair anything on the daughter board that has the controls for the left joycon input ? The component for the screens backlighting is on that board .
  6. Mojoswagger1980

    Hacking PICOFLY SWITCH OLED Cannot boot to OFW & EMMC slower mode will show up and then disappear after rebooting

    No I meant SRAM (located next to the APU on the main board) . But Toshiba does make an emmc for it or at least they did for the Eristar . The Marikos use BGA emmc largely due to Team Executer first mod chip that required the emmc to be removed from its housing and placed in a housing in the flex...
  7. Mojoswagger1980

    How to move from a defective SD card to a new one (AutoRCM, without emunand)?

    Just get a new card and start over . Take that one out, allow the device to show no sdcard and go from there . Get a Scandisk if at possible .
  8. Mojoswagger1980

    Can a mig switch theoretically be used as an SD card reader?

    You can with the dumper . It can be interfaced through the usbc port and I watched a YouTube vid showing it running minecraft from it
  9. Mojoswagger1980

    Hardware Switch Lite - Sd card failed to init (Error 2016-0641)

    That is a n-channel mosfet it is most likely the problem . Thumb drives have them built into them they pass voltage to a serial bus that IDs it as external storage . Sdcards are big enough to house one so the reader has to have one .
  10. Mojoswagger1980

    Hardware SD Card Failed To Init SD Card Reader Not Properly Seated

    Is the card formatted correctly (FAT32) ? If the card is new they are typically formatted in FAT . 1721976585 Disregard the above . The sdcard reader isnt seated correctly ? Did you try reflowing it ?
  11. Mojoswagger1980

    Switch Lite SD card reader issue

    It's a n-channel mosfet used primarily to communicate from a usb device to the serial bus. For example when a thumb drive is inserted into a usb port a n-channel mosfet inside the drive passes specified voltage to the bus and that IDs it as external storage .
  12. Mojoswagger1980

    Glitched screen after inserting micro sd card.

    Is the card readable outside the switch ? Can u put it in a pc or phone and see if it shows up as storage ?
  13. Mojoswagger1980

    New Issue with Picofly (RP2040) on Switch Lite

    Hmmm. Maybe try cleaning the caps on the apu u didn't solder with flux . They look like they have corrosion on them in the pick . I know long shot but maybe and it cant hurt and you mentioned replacing the daughter board. Do u have the original one ? Maybe try it .
  14. Mojoswagger1980

    Hacking PICOFLY SWITCH OLED Cannot boot to OFW & EMMC slower mode will show up and then disappear after rebooting

    The Switch has 2 different ram vendors . Hynix and Samsung . Samsung does not manufacture Sky Hynix ram its parent company Hynix does . Most switchs are Hynix . 1721973125 No it isnt. Sky Hynix is in no way affiliated with Samsung . It is manufactured by its parent company Hynix .
  15. Mojoswagger1980

    Hacking Hardware OLED Picofly: sleep mode battery draining + Joycon jiggle

    Right Joycon . Long press home to get the menu to sleep . But idk if it's the joycon . Does it do this while connected in console and handheld mode ? Does it do it when using Atmosphere or just Lakka ?
See more