Recent content by krackpack

  1. K

    Hardware Switch fan goes full power when I shut the console off

    So i bought the switch off ebay it didnt work at all then I reflowed some of the capacitors by the usb that were discolored and it started to charge. But when I shut it all the way off the fan just goes crazy and blows a full power and wont stop till I turn it on or let it run the battery out...
  2. K

    Hardware Looking for guidance with a switch that shows charging symbol but wont charge

    I had 2 switches do this same thing. I found a cap that was near the usb-c that had no continuity and i used my solder iron and reheated them and it started to charge again. The other one i bought offline broke. But inside there was a few caps that looked liked they were burnt a bit and i...
  3. K

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    ya it does now i just solder it in the switch i dont need to copy over anyfiles besides the rebug one i just dragged over that made it pop up switchboot
  4. K

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    thanks it worked perfect but since i flashed the trinket bootloader on to the switchme do i use the switch boot 1 files for the trinket or still the rebug files im gonna do both straps and just cant find anywere thats says which one to use if i did the trinket bootloader
  5. K

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    so that was the issue i changed that but now its failed to erase i checked its soldered good i reflow stuff all the time so i know thats not the issue but if you got any ideas
  6. K

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    auto i got it hooked to the gpio pins i used the wiring diagrams from the same place as the openocd image from the same place i got the image and yes using the one from the op is there something i am missing do i need to hit the reset at a certain time. i go to the folder...
  7. K

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    can some one point me to were you can get info on burning a sam21 bootloader on a fresh chip on a diy rebug switchme. I ordered the boards and part soldered it all up and i cant for the life of me figure it out. i have read the adfruit guide for openocd and installed the image. But i only had a...
See more