Separate names with a comma.
If you can get into rcm, and load payloads, I'd start with a full nand dump and try using choix to do a OFW update. Restore from backup if it...
Curious, if I flash part 1, to change my straps, do I also need to flash part 2 as well? I have, but curious if it's actually needed. Thanks
Finally got a decent picture of the affected area. As you can see with the arrow, the pad is gone. I added a jumper from pin 3 in the header,...
I have a similar issue, and ripped out a pad by accident, the one after the ribbon connector, so I guess the "distination" trace. Technically I...
I've not seen any feature like that from homebrew or nintendo itself. The only thing I could think of is a PG SD card and an adults SD card....
That is awesome, thank you! Curious, the line you run from the bottom of the resistor, does that go to the empty pad next to it and connects to...
Would anybody have a high res scan of the PCB like in the instructions but without the markings by chance? I messed up a pad and need to repair...
Would anybody have a high res scan of the switch pcb with no markings? I'm trying to repair a ripped pad for the volume + button. I need to figure...
I had the same issue, just download a new boot.dat from the sx site and you should be good to go. Worked for me at least.
I have a quick question.. I have it installed but due to cooling mods, the trinket button is not accessible with a back press, which is fine as I...
