Recent content by Jdlat

  1. Jdlat

    Oled switch won't turn on after Hekate went to sleep

    I had the same problem in my oled and problem was clk . Check it.
  2. Jdlat

    Switch oled turn on problem

    Hi all, i dont know whats happening with my switch oled. My switch oled works fine but sometimes it doesnt turn on. So i have to unmount the console, unplug the battery conector and plug it again , then console turn on. But sometimes when i mount all the console, it doesnt turn on and I have...
  3. Jdlat

    Hacking Hardware Picofly - a HWFLY switch modchip

    Hi all, i have finished 2 switchs, one V2 and one Oled. I want to talk about the Oled + picofly. I did a good installation, and I had a purple screen. I checked everything, i didnt see any problem (I used the v6 dat0 adapter). I removed the entire installation and I cleaned everything. I...
  4. Jdlat

    Picofly AIO Thread

    Only one more question. 3.3v regulator in the rp2040 have to be removed?
  5. Jdlat

    Picofly AIO Thread

    I am a bit confused now, because I have read led have to be Red when programming is finished. However in the picofly guide doesnt say nothing. If you say programmig its ok i will continue with the installation. I am using the 2.75 firmware. I have tested with 2.73 too. Many thanks for your...
  6. Jdlat

    Picofly AIO Thread

    Hi all, I have a problem with the rp2040. I bought it from amazon, when i program it, led is Green when flashing is complete. I read that Green is wrong, right is Red. If i bridge the rgb poonts, nothing changes, Led is Green again. When i conect the rp 2040 (programmed) to the pc, led is blue...
See more