Both are 4.5 kohm
Also did a reflow of the TPM, but no change.
Also, I do get 3V3 on Pin 8 and 22 when applying power, but goes away after a couple seconds.
Yeah, I just measured and get 3.3V when DC is connected, but it stops after a couple seconds.
Not sure what to troubleshoot next. I don't get the 1.8V rails as mentioned in the OP, but should those only be present at start button press?
I have this EDM-010 which I know is a very low firmware, however I can't figure out the fault. It turns on blue, one sec and then off. UART gives me 80800014 - TPM 2.0 chip / power failure. I've checked VCC on the TPM and I get 0v, so not power...