Recent content by Goseph

  1. Goseph

    Hacking Reisyukaku teases ReiNX (CFW)

    Save us Rei-sama
  2. Goseph

    Homebrew Discussion SX OS Crack Thread

    You can also shoot through a bulletproof plate if you shoot it enough times. It's bulletproof in the sense that it's impossible to compute in a reasonable amount of time with current hardware.
  3. Goseph

    Homebrew Discussion SX OS Crack Thread

    It's not the encryption that gets broken, it's the implementation. The math is bulletproof, human programmers aren't.
  4. Goseph

    Hacking WIP Been working on a little something.

    That might be useful, I will contact you if I need programming assistance. Not my biggest strength :) And some updates. I will soon be finished with my exams this will allow a lot more time for this project. I'm adding a 16MB SPI flash - very large payloads! I've also considered adding...
  5. Goseph

    Hacking WIP Been working on a little something.

    I like that idea. Having all the information in one place makes it so much easier for the end user.
  6. Goseph

    Hacking WIP Been working on a little something.

    Maybe. We'll see when i get the prototypes :)
  7. Goseph

    Hacking WIP Been working on a little something.

    Yeah, that's also what I've decided on. I was just a dofus and didn't read the reswitched hardware documentation properly, I found it odd that no reset TP was discovered, until i took the time to read it properly :glare:
  8. Goseph

    Hacking WIP Been working on a little something.

    Shouldn't be that difficult to handle, I'll take some measurements with my scope to be sure. Edit: Found a reset signal, no worries.
  9. Goseph

    Hacking WIP Been working on a little something.

    I added the R pad for compatibility with software for rebugs modchip, haven't really looked for a reset signal. Current plan is to read from an always on power supply like the ram supply, that should be a pretty good way to ensure that the chip only runs on power on and not when you wake it up...
  10. Goseph

    Hacking WIP Been working on a little something.

    Thats a great idea. I will modify the design and add the diode and a jumper for bypassing it for experimentation purposes. Another method to achieve this could be to toggle the pin as a high impedance input after RCM is booted, that way it would be practically invisible to the switch, even...
  11. Goseph

    Hacking WIP Been working on a little something.

    ATSAMD21E, since some nicely functional fusee gelee code exists for it. It's also very cheap and has a lot of great features like usb-host built in. Another plus is that I have already worked with atmel chips a couple times, so writing code should be a bit faster. Haven't done much ARM though...
  12. Goseph

    Hacking WIP Been working on a little something.

    Not at all. You just have to solder wires to the right pads in the console, the the chip will do the rest.
  13. Goseph

    Hacking WIP Been working on a little something.

    It is open source. I'm not in this for profit and I will definitely provide all schematics, source code and gerbers when I have it at least semi functional. I am getting some prototypes manufactured right now, but the next month is going to be busy with exams so the amount of work i can do is...
  14. Goseph

    Hacking WIP Been working on a little something.

    Agreed. There is no reason to use any of those methods if it's not explicitly needed.
  15. Goseph

    Hacking WIP Been working on a little something.

    It will ground pin 10 at boot.
See more