Recent content by Goldenman66

  1. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    WOW it was very easy to use Atmosphere to setup emuMMC with the new SD card and it's very fast too it takes 11m only. thanks a lot for all your support should i restore the NAND backup? also what is the next step to install NSPs and start play offline?
  2. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    sorry dear i have a two similar cards Samsung 128GB and i don't know there is a fake cards in the market also they are expensive not cheap. i'll buy another card and try again. thanks a lot
  3. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    @tabzer it seems SD card is the problem after testing it's defective here under the result of testing Warning: Only 127866 of 127936 MByte tested. The media is likely to be defective. 14.8 GByte OK (31138359 sectors) 110.0 GByte DATA LOST (230731209 sectors) Details:0 KByte overwritten (0...
  4. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    Yes I think sd is good but will check also to be sure, I think it may be firmware version
  5. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    Verification process will take long time and i’ll share with you the results, here is a link for my sd card https://www.amazon.com/Samsung-mc128d-128gb-Uhs-i-Adapter/dp/B0118LR9Z8
  6. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    Ok i’ll use the software you share to check the sd card then will try again
  7. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    i tried to replace hekate_ipl.ini file and this time there is a behavior change switch reboots showing hekate logo then logo disappeared and show again (like logo flash twice), then i opened the ini files and compare them the difference is 1st one use fusee-secondary.bin and 2nd use...
  8. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    Hello @tabzer , here is the steps i did: 1- switch never connected to the internet but i put it to airplane mode. 2- delete sd card partitions and recreated with the values at your post. 3- download latest atmosphere 0.9.3 without fusee-primary...
  9. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    Exactly, and I tried different SD cards also auto Will try again and send you, thanks a lot for your support
  10. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    I tried to use hekate/nyx to create+enable emummc earlier before using dd method with same results, this is the main issue i have when using hekate to create emummc it’s created successfully but when trying to launch it reboot into hekate again also after using dd command and update ini file as...
  11. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    even after i created this folder same issue
  12. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    after i edit ini file as your configuration under emuMMC info it shows enabled but when i tried to launch it it reboots again to hekate. also RAW1 folder is not exists on the SD card should i create it?
  13. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    file extension is right and hexadecimal number also auto i can't enable it, it is dimmed should i create emunand from hekate to enable it?, also the hexadecimal value is the same as SD RAW 1 sector start, ini file configuration is " [emummc] emummc_enabled = 1 emummc_sector = 0xB980800...
  14. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    Now when i press to launch emunand from hekate it reboot and show atmosphere logo, also at system info version is 4.1.0 (ams 0.9.2) but when I change switch name at emunand it changed also at ofw I think it should be different, right? Another thing is at hekate emunand is disabled. I’m afraid...
  15. G

    Hacking Question what is the best scenario for brand new unpatched switch with firmware 4.1.0?

    what is the required configuration exactly? i copied hekate and atmosphere files to SD card and create folder emummc and inside it i created emummc.ini file and write the hexadecimal value for sector number of second partition
See more