Recent content by foxm2k

  1. F

    Hardware WBFS HDD: Not initialized

    Also had the some issue that I realized it was actually not WBFS but instead EXT3 format. Maybe you have the same.
  2. F

    Hacking CompC's amiibo Cards!

    Makes sense. Thank you!
  3. F

    Hacking CompC's amiibo Cards!

    Sorry don't see signature !?
  4. F

    Hacking Switch Xecuter SX Offline play avoid Ban?

    You used SX FW only or SX Pro ??
  5. F

    Hacking SWITCH NOOB PARADISE - Ask questions here

    Hi Mr. Wizard, thanks for your quick reply. Unfortunately The linked thread answers my question not 100% clear... 1.If I enter Flight Mode in original FW and Shutdown console, 2. then use Jig to enter Repair Mode manually each time and 3. If I NOT install SX for boot... only run it from...
  6. F

    Hacking SWITCH NOOB PARADISE - Ask questions here

    Hi, is there a way to launch backups without modifying the console in a persistent way? E.g. when running SX Pro Dongle it will run a custom Firmware right? But will this change my switch permanentely or is this written only to RAM when using the dongle and after reboot everything is original...
  7. F

    Official hakchi2 - NES Mini very simple pimp tool

    Is this Software (Hakchi2) for nes AND snes? Or is there one program for each? Thx.
  8. F

    Hacking [Tools] AmiiBomb

    Ok, now I understand! I am missing the pins you soldered to the RFID board. Gives you the opportunity to completely unwire everything just in case. Just ordered some. Project will continue on tuesday :-) Thanks a lot! Best regards
  9. F

    Hacking [Tools] AmiiBomb

    Thanks @mech for the quick reply. Yep female ports on the R3 and holes on the RFID board. So you are connecting wires (male-male?) to connect the female plugs on the R3 and those of the wires you soldered on the RFID? Wire to wire? My board did not come with wires.. only have those m-f ...
  10. F

    Hacking [Tools] AmiiBomb

    Hi, I bought male-female connectors but seems I need male-male !? OP says "You have to solder the pins on the RC522 Module" assuming the Arduino Uno R3 needs the female ones... Mine looks like it's intended to plug-in male connectors. Can anyone confirm or do I miss something here?
See more
General chit-chat
Help Users
  • No one is chatting at the moment.
    BakerMan @ BakerMan: this one