Hello guys,
Sorry Im out of the topic but I throw a bottle here in case :)
Im looking for a cnc milling machine or a fiber laser to do PCB reverse engineering and Im sure here I can find some specialists !
The goal is too delayer a PCB. I...
Hello Guys,
I repaired another OLED switch, this time a Zelda edition, but in sleep mode the joycons are jiggling and the battery is draining like hell.
What I already tried:
- I swapped the MB in another oled console and its the same,
- same...
Thanks for helping, I fixed it. It was something ridiculous… the vcc wire on the pico was broken … I didn’t see it under the kapton tape 😂
This one is fully working now 👌🏻
Which RP2040 board are you using?
It looks like your console is stuck in one of the boot stages. More details about fault diagnostic and general boot sequence you can find on this (excellent) wiki...
Please do not laugh, since the moment I removed the ic driver to try to remove the shortcut on the pin 28 the vcc wire of the picofly was broken … the issue was the hint you gave me. At least like that I did a permanent dat0 and I reconnected the...
Hello, just before that, the console was booting but the screen was not working cos the dat0 adapter shorted the 2 tests points above the emmc, so I was thinking that the oled driver ic was faulty so I removed it to try without. And since this...
Hello,
I have an OLED refusing to turn on.
I can see no damages on the board, no shortcuts around power management ICs and the driver of the screen.
The board draws :
Screen connected
- with battery: 0,469A
- without battery : 0,033A and if I...
Damn Im so upset it was that, but I touch the driver etc… Im good to buy a new one 😅
Thanks ! At least I learned something more, next time I put solder mask on these points before fixing the dat0 adapter on the emmc.
1713204905
Ok all my...
Hello Guys,
Im trying to repair an OLED switch with blackscreen.
- the console is fully functional docked
- I change 2 times the screen connector
- I swap the motherboard to try the screen (is working)
- the tactile is functioning
I made...