Recent content by dotnesia

  1. D

    PS5 Slim (EDM-044) - 2s BLOD - Error 80871060

    The board traces looks connected to the chip on the right side, i think it's ram for ssd. I would try to remove both and do measure.
  2. D

    PS5 Digital edm-030 2 sec blod (cracked GDDR6 RAM) 80800022

    Had you check on power voltage? Wifi chip can cause blod too, but usually there is some error code appeared.
  3. D

    PS5 Digital edm-030 2 sec blod (cracked GDDR6 RAM) 80800022

    Sorry, i mean bios chip near southbridge. What is the state of "blod" ? Only blue light stays on? Pulsing blue light? Blue light 2-3seconds then 3 beeps? There is several blue light symptom as i'm aware, can cause by different issue. It's better to check every power voltage needed to boot, you...
  4. D

    PS5 Digital edm-030 2 sec blod (cracked GDDR6 RAM) 80800022

    Check nor ic, data might be corrupted.
  5. D

    PS5 Digital edm-030 2 sec blod (cracked GDDR6 RAM) 80800022

    Maybe 1uf, You can check cap on another banks. Should be the same value. https://gbatemp.net/threads/ps5-slim-edm-140-blod-ram-calibration-impedance-error-diagnostics-so-far-error-code-80801510.679366/ This for different board revision, usually not much different.
  6. D

    PS5 Digital edm-030 2 sec blod (cracked GDDR6 RAM) 80800022

    It could be just a bad ram chip or bad soldering. Not sure if the ps5 need special treatment after ram swap. But it should be not needed any. I've never seen anything like this in smartphones for an example. Only replace then it will be done. Wait for several minutes when blue light stays on...
  7. D

    PS5 Digital edm-030 2 sec blod (cracked GDDR6 RAM) 80800022

    Never seen cracked chip from blown psu, Some chip may cracked if power surge cause by lightning struck. But the other component mostly will be dead also, and the damaged "normally" visible. Like burned component, and sometimes component melted down into the board, like fused together cause by...
See more