Recent content by dodo136

  1. D

    Hacking Hardware Picofly - a HWFLY switch modchip

    it was the cmd resistor i replaced it and it works now ty evryone
  2. D

    Hacking Hardware Picofly - a HWFLY switch modchip

    PURPLE SCREEN i removed the ribbon cable and checked the resistor again it was blown i don't remember the last time i measured it was ok before or after i installed the ribbon i hope its just the resistor and the emmc is still good i dont have a resistor for now to replace i found a 4.6k...
  3. D

    help me with failed oled modding

    I Checked the 4.7k resistor and it wan blowen i hope that is the issue and my emmc is still fine i dont have a resistor to relace for now i found 4.6k on a doner switch v1 bord i dont know if it fine to solder it shorting 100ohm or not i dont wanna risk fry the emmc if it is still ok what do you...
  4. D

    Hacking Hardware Picofly - a HWFLY switch modchip

    help me wth failed oled modding i modded my switch with kamikazi method first i accidently cut the dat0 trace the console didn't boot at all just black screen i manage to put small solder blob to bridge the cut trace and checked in diode mode to make sure its not shorted the console boots i...
  5. D

    Picofly AIO Thread

    I don't know . How to check this ? I will send a photo of the chip when i arrive home I soldered the jumper wire from dat0 via kamikaze point directly to the picofly board Its one of those boards off AliExpress i watch many YouTube guides no mention of adding resistors
  6. D

    help me with failed oled modding

    edit : i fixed it see update 2 i will leave the topic in case someone faces the same issue help me with failed oled modding i modded my switch with kamikazi method first i accidently cut the dat0 trace the console didn't boot at all just black screen i manage to put small solder blob to...
  7. D

    Picofly AIO Thread

    help me wth failed oled modding i modded my switch with kamikazi method first i accidently cut the dat0 trace the console didn't boot at all just black screen i manage to put small solder blob to bridge the cut trace and checked in diode mode to make sure its not shorted the console boots i...
See more