Recent content by djuniah

  1. D

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Will it drain the battery below the min voltage that the charge controller is set to work with? It seems odd that they would design it in a way where it would brick the battery if it sits for a month or two (un-modded). Do you know if the 3v pads listed in the instructions run through the...
  2. D

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Sorry, i'm not referring to standby/sleep in either of my posts, i'm talking about fully powered off. Do both the picofly and trinket mods drain while the system is completely off?
  3. D

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Ah interesting, I had only seen the warning about that in this thread and couldn't find any mentions of it in relation to the picofly anywhere else online when I searched. If that truly is the case, i'm thinking maybe it might be a good idea to connect a very small switch to the 3v line and cut...
  4. D

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    I had installed this mod a little over two years ago, it's been really great and i have only one real issue with it which is the phantom battery drain. I don't use the console all the time and the battery keeps draining dangerously low when it sits too long, which isn't great for the battery in...
  5. D

    Homebrew WIP Status Monitor Overlay - Tesla Overlay to monitor your hardware

    Yes I am running the latest version of the overlay(It was a fresh install of the overlay and tesla is updated to the latest available). I also did try holding down both sticks to exit but it did nothing. I'll try re-installing everything. Just wanted to make sure there wasn't some other...
  6. D

    Homebrew WIP Status Monitor Overlay - Tesla Overlay to monitor your hardware

    I'm sorry if this is a really dumb question, but I can't seem to open the tesla menu anymore once I enable this overlay. I tried the normal tesla button combo (L-DpadDown-RightStick) and it does nothing. I also tried holding both left/right stick as i saw that can be used to exit the overlay...
  7. D

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Great thanks for the info. I'm not really trying to improve over stock, just want to make sure that it's still within expected ranges and that I didn't screw anything up.
  8. D

    Issues moving a DLC from sysNAND to emuNAND

    Just wanted to say thanks for that advice! It totally worked!
  9. D

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    I'm not posting these pictures because i need help, i'm posting them because i'm shocked at how smoothly this all went! I'm up and running! There was some wire clean-up done after that close-up shot, and I also replaced the thermal paste. This was my first time working with anything less than...
  10. D

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Sorry if these seem like really basic questions, but i'm just gathering my materials and info to give this a try and had a couple of questions. Should I be putting down a layer of kapton tape in between the shield and my trinket m0? I didn't see it mentioned but wouldn't it short out without...
  11. D

    Issues moving a DLC from sysNAND to emuNAND

    Ah so if i remember correctly nxdump had an option to remove console specific data when I created the DLC NSP. I don't think I enabled that. If i re-do the dump with that enabled, it should help? I did also try dumping the ticket for that DLC and manually installing it on my emunand (I do have...
  12. D

    Issues moving a DLC from sysNAND to emuNAND

    Yeah it's not a massive game by any means, but it's still redundant space if i could just use the cart.
  13. D

    Issues moving a DLC from sysNAND to emuNAND

    Right, so your summary of the situation is correct, but the game cart slot definitely works in emunand. I have run the game off of the cart prior to installing the DLC, and if I uninstall the DLC.nsp it works again. It's only after installing that nsp that I get the error. I would prefer not...
  14. D

    Issues moving a DLC from sysNAND to emuNAND

    Only reason would be to keep using it on sysnand, but that really doesn't matter anymore. Honestly, that's the only game i purchased a physical copy of and it's just lived in my switch since i got it. EDIT: To be clear, I purchased the DLC on the eshop on my sysnand, then turned on airplane...
  15. D

    Issues moving a DLC from sysNAND to emuNAND

    Ah interesting. So I had tried to launch the old icon for the cart from the home screen, i wasn't launching the DLC directly (or at least I didn't THINK was). Is there any way to install the DLC from an NSP and use it with a cart?
See more