Recent content by Crihaxx

  1. Crihaxx

    Hacking Nintendo switch oled hwfly v4.1 not starting purple light blinking with black screen.

    Hello, my console switch oled with 4.1 hwfly installed on is not starting after yesterday. I had unresposive right joycon (my console only recognized it if i use detached from the console) so i tried to reboot the system and this problem appeared. I already tried hard reset for 15 secs but with...
  2. Crihaxx

    Switch oled hwfly stuck on black screen with purple flashing then red

    He tried literally everything, also changing mac77812 pmic and reballing the emmc but no results unfortunately..
  3. Crihaxx

    Switch oled hwfly stuck on black screen with purple flashing then red

    The installer said me he measured a kohm resistance between D and gnd. He said normally this should be around 4-5 Mohm, so he thinks this is a faulty emmc or apu which could happen in some switch console. Have to swap the motherboard unfortunately.
  4. Crihaxx

    Switch not turning on, light on hwfly, shorted caps

    Yes, it was working after i bought it, already with hwfly on. I noticed only that sometimes i had problems on sleep mode, console completely freezed and unresponsive joycons. Haven’t checked the dat0 under emmc soldering point if you mean that one, this is the next step which will be done by the...
  5. Crihaxx

    Switch not turning on, light on hwfly, shorted caps

    Hi there, My switch oled isn’t booting up, hwfly with purple light then red and so on. Sometimes when leaving in this condition boots into hekate, but very rare to happen. Measured diodes on hwfly and values are in range, also for sp1 and sp2 resistances. Found that there are some shorted caps...
  6. Crihaxx

    Switch oled hwfly stuck on black screen with purple flashing then red

    Measured shorts on capacitances in this point..what can be the solution? Edit: the upper part on first photo are capacitances right under the apu. Moreover i found also another point with shorted capacitances, lower respect to the hwfly chip.
  7. Crihaxx

    Switch oled hwfly stuck on black screen with purple flashing then red

    I hope it’s dat0 and not for example a corrupted emmc. But at this point i’ll give to him next week then will see. For sure I’ll give an update here for someone in future who could be looking for same infos.
  8. Crihaxx

    Switch oled hwfly stuck on black screen with purple flashing then red

    I made the console to fully discharge, not have opened again it up, but there was yellow then a fast red then again yellow (instead of purple). I think a fast try could be to unplug the hwfly and desolder the rst to test if without the chip the console is working. 1680802516 Checked also...
  9. Crihaxx

    Switch oled hwfly stuck on black screen with purple flashing then red

    Unfortunately I’ll give him the switch next week after easter. Moreover because i bought the console (which I tested before and it was working fine) from a guy who made it being modded from him, he’s asking a 30€ fee for doing a check to see what’s happening and then if it is an hardware thing...
  10. Crihaxx

    Switch oled hwfly stuck on black screen with purple flashing then red

    So if I desolder the point B and unplug the flat going from sp1 and sp2 to the hwfly board it should work in ofw? I don’t know if you have read new messages but yesterday night after leaving trying to glitch i found it on hekate but when trying to boot it didn’t and moreover in emmc info i’ve...
  11. Crihaxx

    HWFLY Oled - Purple into Red Light, not booting after restart.

    So you made the battery to completely drain and then? You recharged fully and then retried or you directly tried booting after putting it in charge? I ask you because you are describing my exactly situation now.
  12. Crihaxx

    Switch oled hwfly stuck on black screen with purple flashing then red

    Also seen on another thread that also draining the battery could help in resetting the chip. I’ll try this before trying on the chip with tweezers..unfortunately don’t have usb port for resetting with Putty. After these tries then I’ll give the ball to the installer. 1680677237 I let the console...
  13. Crihaxx

    HWFLY Oled - Purple into Red Light, not booting after restart.

    But it was booting to ofw or you had black screen with only purple then red light on chip? I think i’m facing this issue, mine isn’t booting also in ofw, maybe a reset of chip could help.
  14. Crihaxx

    Switch oled hwfly stuck on black screen with purple flashing then red

    Checked the diodes on D, A, C , 3.3V and B and they are in range around less than 0.5V (something like 0.46V). I didn’t check the resistors to sp1 and sp2 vs gnd. Also tried to disconnect the battery and the flex on the hwfly coming from sp1 and sp2 point but still nothing. At this point only...
  15. Crihaxx

    Switch oled hwfly stuck on black screen with purple flashing then red

    I’ll definely get in touch with the installer and make him check it. So just to do a test, if i unplug the flat from hwfly to make the console to not see the modchip it should boot on ofw? Maybe i could try this.
See more