Recent content by cowboy619

  1. cowboy619

    Hardware GBA SP "R" Trigger not working

    These have been really good - you flash a custom firmware on them and runs like a dream https://s.click.aliexpress.com/e/_c4aY4gCB
  2. cowboy619

    Hardware GBA SP "R" Trigger not working

    As per picture ran the jumper and for it working
  3. cowboy619

    Hacking Hardware Picofly - a HWFLY switch modchip

    Damaged pin in the fpc connector near battery
  4. cowboy619

    Hacking Hardware Picofly - a HWFLY switch modchip

    Toolbox is in payload - put the uf2 file in the root of sd card
  5. cowboy619

    Hacking Hardware Picofly - a HWFLY switch modchip

    2.8 is the latest but no real need in updating
  6. cowboy619

    Hacking Hardware Can I Hard Mod A Switch Without Soldering?

    You can mod it without soldering just send it to someone who can solder :)
  7. cowboy619

    Hacking Hardware Picofly - a HWFLY switch modchip

    No dat 0 needs to be 100ohm and cmd needs to be 100ohm
  8. cowboy619

    Hacking Hardware Picofly - a HWFLY switch modchip

    These ones are good https://s.click.aliexpress.com/e/_okNewc6 1748083373 Thats just an anchor point 1748083433 0201 you need to add a total on each point 100ohms to DAT 0 and CMD
  9. cowboy619

    Hacking Hardware Picofly - a HWFLY switch modchip

    Dat 0 and CMD needs to have a total of 100ohm - measure the current setup and then add accordingly 1747811676 B should be around 1.7v and 2.9v - you should be fine - ps i dont like those flexes i prefer running wires or using the latest flex for lite's
  10. cowboy619

    Hacking Hardware Picofly - a HWFLY switch modchip

    Installing a Picofly Tiny in a V2 after it glitches the chiip works great but does not shutdown after glitching - running 2.80. Anything i should check
  11. cowboy619

    Hacking Hardware Picofly - a HWFLY switch modchip

    you add the resistors to the resistors on the chip itself. Not on the wires - check the resistors on the chip
  12. cowboy619

    Hacking Hardware Picofly - a HWFLY switch modchip

    add 47ohm resistors to dat0 and cmd - both points need to have a total of 100ohms so dat 0 100ohm and cmd 100ohm
  13. cowboy619

    Hacking Hardware Picofly - a HWFLY switch modchip

    Was about to say that - i dont like that old flex on the lites i prefer a wire run 1742455061 dat 0 and cmd needs to each have a total of 100ohm on each point
  14. cowboy619

    Hacking Hardware Picofly - a HWFLY switch modchip

    Follow the 2 middle pins
See more