I think I understand what you meant by trigger. I was to set the trigger so that I would essentially record a specific event. I think the reason the CLK is "flickering" is because in those clips, I didn't have a specific trigger set. I was mainly...
I think I may have some good news (or at the very least something of note). I went and tried the oscilloscope again on Thursday and I adjusted the vertical sensitivity, and I'm not sure if it helped or if it was something else, but I was able to...
That's what I thought, but that just makes it more confusing as to why I couldn't capture the falling edge. Maybe it was the vertical sensitivity?
1711390308
I can try again with the oscilloscope using a greater vertical sensitivity, otherwise...
I looked it up and the sampling rate varies from 5 GS/s on 1 channel, 2.5 GS/s on 2 channels, and 1.25 GS/s on 3 or 4 channels. I don't see anything regarding frequency when it comes to sampling rate, however I can say that the bandwidth is 1...
Interesting. Any ideas on why it seems to shoots up to 3V3 (idle state) so quickly? Or perhaps as you said, the oscilloscope isn't capturing it on low so the only thing I'm seeing is 3V3, thus giving us the wrong idea. I don't know if it's...
You did indeed share a version of minute that doesn’t turn the mlc on. I can give that a try. When you say not to point in IOSU, do you mean don’t try to patch & boot? Just turn on the Wii U with de_Fuse and that version of minute and then...
I measured around 0 V when measuring CMD to GND with the power supply plugged in (but the Wii U not powered on), with some mV fluctuations, so it doesn't look like there's a short there.
I did find 3V3 at C1257, and with the power adapter...
I measured 10.13 kohms for the resistance between CMD and 3V3 which to me seems reasonably high. When I measured the voltage between 3V3 and CMD (plugged in, but not powered on), I at first got mV readings that seemed to keep growing, but when I...
Understood. You specified the NAND-AID for the voltage. Can I just use the pads on the NAND-AID for all the measurements or should I be measuring at different points for some of them? I assume the NAND-AID would work just fine since it’s directly...
What points should I be putting the multimeter probes on the measure resistance for 3V3 and voltage? I’m assuming one probe on the 3V3 pad, so would the other probe be on GND?
I tried both falling and rising edge. I initially started with falling edge before messing around with rising edge because the trigger on falling edge never triggered. I suppose it's possible I somehow missed it, but I tried several times and...
guys i just checked to see what's in the fortnite item shop today and saw that metallica skins, atla skins and jjk skins are in the item shop at the same time rn, shit's not real
Btw it seems like the user dtapple disabled others posting on their profile, either they are going through something or they blocked me. Better leave them alone ig