Recent content by buggyuser323

  1. B

    Hacking SWITCH NOOB PARADISE - Ask questions here

    hi dears, i hastily upgraded my modchip oled without following this guide (not uninstalling themes, no pre-prep steps taken apart from clicking backup in hekate and copying entire sd card to pc) ( https://gbatemp.net/threads/ultimate-guide-to-upgrade-your-firmware-atmosphere.661148/ ) and now my...
  2. B

    Hacking Gaming ROM Hack BOTW : Accidentally Deleted save file

    ah crap. i think im right around there - i beat the volcano boss, next up is ganon. exported from jksv. see if this works!
  3. B

    Hacking Hardware Picofly - a HWFLY switch modchip

    Dears, I managed to install the modchip on my oled, and it works well! (using better solder and flux was key). I've used the (rp2040 v3?) modkit with all its flex cables and adapters. Only one issue: when i attach the left joycon, it recognizes with animation/sound and plays fine BUT doesn't...
  4. B

    Picofly AIO Thread

    Ok, took all the cables, adapters and everything off, it still boots into ofw. I'll look for better solder, pick up another modchip packet, and try again. Should I be extra mindful of something before my next attempt?
  5. B

    Picofly AIO Thread

    Dears I tried redoing all the connections again, with emphasis on not having cold joints. (lots of SRA flux, 380c, good contact) I still get the dreaded *== yellow. What can I try next? Do you see something wrong in my attachments and the readings? (All readings taken red on ground, black on...
  6. B

    Picofly AIO Thread

    Dears, I am haunted by a yellow *== (No eMMC CMD1 request (poor wiring, or dead CPU)) on my oled chip install. Redid all the connections, everything reported in the correct ranges (sorry too tired to go back and note exact values) but this is my first attempt at soldering so im sure i must have...
  7. B

    Hacking Hardware Picofly - a HWFLY switch modchip

    I _just_ seem unable to disconnect these two connections. I've used a lot of force, pushing sideways, used tweezers, a couple of pointy sticks, nothing seems to work, and I might have broken off the top ledge-type thing that I see people leveraging against to push open with their tweezers. A lot...
See more