Recent content by Bl_BR

  1. Bl_BR

    switch does not start is stuck on the logo screen

    well, has anyone gone through this, the device is stuck on the logo screen, I've tried to enter recovery mode but it won't, I've already changed some ic's on the card like bq* up3 usb connector, reflow in the wifi module... I also did the process to recreate the nand but without success besides...
  2. Bl_BR

    Hacking Hardware Picofly - a HWFLY switch modchip

    in this case, then I will have to open the console and resolder the usb.. because it does not enter hekate, it already starts on this screen
  3. Bl_BR

    Hacking Hardware Picofly - a HWFLY switch modchip

    Can anyone tell me what this is, I left the device turned off for a week, I went to turn it on today, the chip pulses white then blue and finally cyan and it seems to start Ofw but it just stays on this screen and restarting
  4. Bl_BR

    Hacking Hardware McFly - an RP2040 board compatible with Picofly

    @Saliciae How do I test this new modchip? I'm from Brazil and I've been installing for a long time
  5. Bl_BR

    Loading Screen After Installation with Picofly

    Can anyone tell me what this is, I left the device turned off for a week, I went to turn it on today, the chip pulses white then blue and finally cyan and it seems to start Ofw but it just stays on this screen and restarting
  6. Bl_BR

    Problem When trying to start CFW through hekate

    no problem, I'll get back to you 1681408385 I did the test on the eMMc and Cpu connector tracks, they are normal, I tested the SD card connector and it is normal too. I turned it on in RCM mode through Tegra without using the sd card And the image failure continues, so I'm already ruling out...
  7. Bl_BR

    Problem When trying to start CFW through hekate

    ok i will do a check on the board
  8. Bl_BR

    Problem When trying to start CFW through hekate

    I don't think so, because I already tested it with another emmc module and the image failure problem is the same, I also used another sd connector so I'm thinking that it could be a gpu problem other than that the system starts normally without activating the rcm
  9. Bl_BR

    Problem When trying to start CFW through hekate

    I've only tested 1, the 3 work normally on my oled, it's not a problem with the SD
  10. Bl_BR

    Problem When trying to start CFW through hekate

    yes I already tested with 3 different cards. the problem itself is these flaws in the image and in the letters, without activating the unlock the system works normally
  11. Bl_BR

    Problem When trying to start CFW through hekate

    this message does not show I tested the module on another device and it does not show the defect
  12. Bl_BR

    Problem When trying to start CFW through hekate

    I looked and they are normal, I tested another eMMC module and I continue in the same way
  13. Bl_BR

    Problem When trying to start CFW through hekate

    edited
  14. Bl_BR

    Problem When trying to start CFW through hekate

    I have this switch v1 Unpatched for repair, it works normally in the original mode without starting the unlock, but whenever I try to start with the hekate of the different colors on the screen both in cfw and in emunand, in addition to having these scratches on the letters, I have already...
  15. Bl_BR

    Hacking Hardware Picofly - a HWFLY switch modchip

    1679567931 they are in series adding 55 ohm I don't have 47
See more