I am having the same problem as well. Played games then powered it completely off (not sleep mode) now it won’t turn back on at all. Nothing. Doesn’t work with power cord plugged in either.
Thanks for the info. Any suggestions on what to do? It just doesn’t seem like power is getting to the board or something.
Even with the switchme light pulsating which should mean I can connect it to pc, the drive still wouldn’t show up in Windows. Am I looking at a bad motherboard? Anything I...
I did get a new battery in and system still won’t turn on. I moved my 5v wire to the one on the emmc board and changed to 3v connection on switchme. I get no light on the chip but i think that’s becauer the system isn’t on. My other point always had power. When I go back to that point the chip...
Opened it up and no wires came off. Disconnected and reconnected battery. Chip is not even getting a light now. Even with power cable connected. When I put a multimeter on the battery it’s about 2.5v. The battery says 3.7 on it but I’m taking the reading with it connected so im not sure what to...
Autorcm is enabled via the software menu. I am not using the wiring method of the chip to autorcm. Do you know what I mean? Not sure if I am wording it correctly.
Thanks
Hello Bill...
Sounds very strange to me...
Can you take a picture of your install please?
This could be a shorted capacitor point. Or a battery issue. Won`t know more until you post a picture of your install.
:)
I’ll try and get a pic up later tonight after work. It’s just odd that it...
I’m having some issues. I am using one of the original 4 wire methods for my switchme using 5v. Flashed with reinx.uf2. Whenever I power on the switch I basically have to hold the power button down until the menu comes up. Pressing it normally does nothing usually but everything works fine once...
I finally got this to work with the SX_OS.UF2 payload. The others I tried did not do this. The device just stayed there. Never rebooted. Now I am using the 4 wire method and a paperclip to jump the first and last pins of the right controller connection on the console when I power it up but I...
I'm having all sorts of problems with my SwitchMe.
1. I direct wired it to the PC. The REBUG_BOOT drive shows up. I can read from it. When I drag a UF2 file to it, it seems to go there. I cannot remove any of the other files. If I try to they disappear but if I reboot the system the 3 original...
I used the Waninkoko 4.0 updater when WiiSports Resort came out and the Waninkoko 4.1 updater a week ago. Did I screw something up on my system? HBC still works. I have a Wiikey1 installed. 4.1U NTSC.
I have not tried to get this game working yet. Reading the whole thread before I start messing...
I used the Waninkoko updater to update to 4.1U.
Homebrew chan working fine as is other games. What exactly do I need to do? Not sure how I check which IOS's I have installed and what I need to install.
Any help is very appreciated!
thanks!