Recent content by Beaver_27

  1. Beaver_27

    Hacking Hardware Picofly - a HWFLY switch modchip

    Heat them with a heating gun or soldering iron? I have both but i never used a solder suction. Also if i use the heat gun I'll just kapton tape all the surrounding stuff. Thank you for the suggestions tho
  2. Beaver_27

    Hacking Hardware Picofly - a HWFLY switch modchip

    I tryed a wick and it didn't work, I don't have a desoldering pen but i bought one and it will arrive in a week so maybe that would help, and just the heat up and try to move the solder with the iron/tweezers. Also this where it is on the board.
  3. Beaver_27

    Hacking Hardware Picofly - a HWFLY switch modchip

    Hi, i have bridged the two 3.3v caps on the switch v2 motherboard, is it fine to leave it like this? I've been struggling to get the excess solder off.
  4. Beaver_27

    Hacking Hardware Picofly - a HWFLY switch modchip

    Hi, is this dat0 position fine? The diode value is .62v
  5. Beaver_27

    Hacking Hardware Picofly - a HWFLY switch modchip

    I meant cpu flex cable sorry. The 0.1 should be fine right?
  6. Beaver_27

    Hacking Hardware Picofly - a HWFLY switch modchip

    So as i earlier said for me it's blue then white (I'm a little colourblind so i might be wrong), Clk, cpu
  7. Beaver_27

    Hacking Hardware Picofly - a HWFLY switch modchip

    Does the wire the cpu cable need to be thick or it can be 0,1mm magnet wire?
  8. Beaver_27

    Hacking Hardware Picofly - a HWFLY switch modchip

    Hi i tried to do the install but it's giving me a blue then white led and boots to ofw. The rp2040 is on 2.67. It's an oled and i don't have the ribbons for the fan and the left/right joycon rails, but I don't think that should be a probelm.
See more