Recent content by ashrocks94

  1. A

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Yeah I think it's time too haha, so how do I go about sending this to you? Could I possibly just send you the mobo? I ordered a fresh mobo on ebay (patched unfortunately) so I can play some smash.
  2. A

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Desoldered everything. Attached pics.
  3. A

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Doesn't seem like that's the case, the 3V point is still reading as 0.7V
  4. A

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    You have a website for your repair services? I'm 99% sure I've fucked this up, might need to send this over. Is there any documented points on the board to see exactly which component I've broken with my multimeter?
  5. A

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Alright thanks, going to leave it plugged in for a couple hours and report back. I was trying to put the switch back together after putting the chip in, it was booting prior to putting the rear shield back on. Might have shorted it, hopefully don't have to chuck this in the trash :mellow:
  6. A

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    3.8V on my multimeter
  7. A

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Not sure what I did, but after the switch was booting up normally, now I'm only getting .7V on the 3V line... Switch won't power. Any guesses?
See more