Recent content by aramirez0425

  1. aramirez0425

    Hacking Hardware Picofly - a HWFLY switch modchip

    Has anyone had an issue with the modchip just blinking blue for about a minute and a half and then red. Console was glitching fine, for two weeks. Will a reset of the chip work ?
  2. aramirez0425

    Hacking Hardware Picofly - a HWFLY switch modchip

    I cut the end and solder to the resistor as well. much simpler
  3. aramirez0425

    Hacking Hardware Picofly - a HWFLY switch modchip

    yes 1680902808 1680903189 ok... i used the toolbox rollback and it said it flashed and to reboot. After the reboot it just gave me a blinking blue light so i soldered on the usb c port and buttons and flashed the rp with the 2.5 and unlock. From there i booted into ofw and it worked as normal...
  4. aramirez0425

    Hacking Hardware Picofly - a HWFLY switch modchip

    i would check the caps using diode mode, red probe on ground and black probe on either side of the cap. One side of the cap will be ground and should read .000 and the other side should be reading about .010 or so 1680895960 I never had the console running on 2.5. i did flash the rp with 2.5...
  5. aramirez0425

    Hacking Hardware Picofly - a HWFLY switch modchip

    Its no issue really, as i do have more rp2040 and this is my personal console so it all for testing. Just looking for temporary solutions.
  6. aramirez0425

    Hacking Hardware Picofly - a HWFLY switch modchip

    Am on the same boat, i cant boot ofw as well on my an Oled running the latest firmware. Before i modded this console i flashed the 2.5 and then i flashed the 2.6 and once installed i still cant boot ofw. Everything else works fine Also, has anyone tried to roll back to 2.5 using the toolbox to...
  7. aramirez0425

    Hacking Hardware Picofly - a HWFLY switch modchip

    No issues, pretty straight foward. Use stencil, paste and tweezers. Not hard at all.
  8. aramirez0425

    Hacking Hardware Picofly - a HWFLY switch modchip

    Couldn't wait for the my flex cables to arrive. Installed this on an oled and reballed the emmc for the dat0. Boots great!