Recent content by 3L_S4N70

  1. 3L_S4N70

    Picofly AIO Thread

    Dying and finally dead motherboard. So I am in search of a donor unit now. Thanks for all the help provided though :)
  2. 3L_S4N70

    Picofly AIO Thread

    Well, guys, I fixed it by removing the second resistor on the DAT0 line, but not on CMD line. Now it glitches, succesfully enters HEKATE, but... I have encountered another problem: it no longer passes from Nintendo logo on OFW, nor Atmosphere logo on emunand... is the NAND corrupt? Is there...
  3. 3L_S4N70

    Picofly AIO Thread

    Not bridging, but I'll fix, thanks for the advice. That's been the result of multiple trials soldering and desoldering and so, but still no luck :(
  4. 3L_S4N70

    Picofly AIO Thread

    Well, I do not have a flex cable, nor do I think my problem is there (I am not very experienced to be sure of that though 😅). This is my installation, it's not the cleanest, but I have checked values in diode mode, all of them under 700 and over 400 on all the points. I have also checked...
  5. 3L_S4N70

    Picofly AIO Thread

    So probably my problem is with the MOSFETs soldering... I am going to recheck that too. My Picofly is built with a Waveshare Pico board, so I guess the problem is more with my soldering station tip not in good shape, and thus, a deficient solder. Thanks for the idea 😊
  6. 3L_S4N70

    Picofly AIO Thread

    Thanks for the comment, I will check if there is a bridge, I am sure the point is correct (I have checked it -and all the other points- both visually and with the multimeter when possible three times). Nonetheless, I will recheck all the points again with a different diagram just in case I've...
  7. 3L_S4N70

    Picofly AIO Thread

    Hi all. First of all, thanks to the creator for this amazing development. I have a problem, I am receiving a =* error code (thrice), so I think it is indicating a problem with D0, although I've checked continuity from D0 in the NAND board to the Pico, and it seems to be ok. Do you know what...