Hi there all! My xk3y is working with no issues. My disk drive is working fine as well if I physically disconnect xk3y. However if I try to load in pass-through mode (with “eject” button) the drive tray ejects, but dashboard doesn’t load, and the xk3y remote displays “open tray” then “close tray” in endless loop. xk3y is on latest firmware v2.01-4. Drive is 16D2S fleshed with LT3.0. Console is on latest OFW version. I remember pass-through mode was working fine in the past. Did not notice when exactly this issue started, as I wasn’t using my drive for years. Any ideas? Thanks!