Homebrew Updated Emunand 11.3 Black Screen Emunand

[toby1978]

Hello everyone! I have a problem and need some advice! Went to play Super Mario Maker and it prompted me to update it, so I did. I run RXTools and its always worked fine, but now after cold boot loads through I get a black screen. The sysnand is still 9.2! I prefer having the setup I have since its my 5 year olds 2ds. Is there a eaasy fix or do I need to redo the CFW from the start? Thanks for any help on this matter!

 

[KunoichiZ]

Switch to a different CFW. Rxtools broke with the 11.3 update.

 

[VictorMoreno015]

The only three CFW's that I know works on 11.3 is either Luma3DS, Corbenik, and ReiNand. Just switch to one of those 3. Looking at your situation I highly recommend Luma or ReiNand. They are both userfriendly. "Corbenik is mainly intended for developers, power users and control freaks"

 

[Quantumcat]

Look at this for switching to Luma:
https://github.com/AuroraWright/Luma3DS/wiki/Installation-and-upgrade

 

[toby1978]

Thanks for the replies! What is the easiest and fastest to do? All I have atm is the Homebrew channel installed?

 

[Quantumcat]

Thanks for the replies! What is the easiest and fastest to do? All I have atm is the Homebrew channel installed?

If you want the best exploit follow http://3ds.guide. It's longer but because everything is laid out step by step it's easier than doing anything else.

 

[toby1978]

If you want the best exploit follow http://3ds.guide. It's longer but because everything is laid out step by step it's easier than doing anything else.

Following it now! Doing the whole CTRNAND stuff right now, seems to take a bit of time!