holding power button above 15 seconds to shutdown and try it again.
don't forget charging full battery before working.
i am not sure wether there is a hardware problem in your switch.
--------------------- MERGED ---------------------------
if you restored boot0/1 not paired Hos version with current system , it could be brick.
for example, 11.0.0's nand includes boot0, boot1 and rawand, if you restore a old version boot0/1, it must be black screen.
Last edited by paulzheng,
Understood,but as far as I have the full backup with my boot0/boot1 and matched rawnand.I think it's not a big problem IF I can enter RCM,or my computer can pick up my switch.
i saw maybe you are using windows in mac. check usb driver compatible problem. or you can choose to payload with android phone. need a otg adapter in addition.
Well,actually not Windows in Mac,but native Windows and Macbook pro. And also tried with phone...no luck.
Since you also tried phone also, it might not even be in RCM mode that you said you had autoRCM on.
You tried with the jig on the right joycon rail just in case while pressing the correct button?
Yea it is hold down + volume button while pressing the power button, you tried what Gamesquest1 said?
Long story short, I got a success!
After did what gamesquest1 said:
After did what gamesquest1 said:
disconnect battery and the Emmc chip, this will ensure RCM mode will be initiated upon plugging the USB cable in, just reconnect them both before sending your payload over, I don't see how or why you would be failing to get into rcm mode with the jig, but thats a surefire way of ruling out it simply being an issue
my switch successfully picked up by my computer and entered RCM mode. And after I put my nand back on. My payload injected smoothly.
Now, I got a switch with a strange battery level:
So do I need some kind of fix?
And also I definitely need a full nand restore to match my boot0/boot1 right?
Yeah, before the failure I remember my battery capacity is like 4200+ mAh or so.
--------------------- MERGED ---------------------------
And when I plug my charger onto it. It now chargers at 7.5W.
You can try to restart the unit and go back into Hekate see if it recalibrate the battery, if it doesn't then the battery is a goner.
Well,it boot nicely, and also my battery info is now back to normal. I believe it just need a small re-calibration. Now I got a switch with 14 burnt fuses and my backup is 9.0.1 so that means I will need RCM to boot my OFW every time? What will happen if my autoRCM is off? Also, what if I update my OFW to latest?
Similar threads
- No one is chatting at the moment.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
@
SylverReZ:
@cearp, Its fine, the weather isn't as severe unlike certain areas of the US. We don't have tornadoes or severe thunderstorms.+1 -
-
@
cearp:
wet summers are much better than wet winters I think. Horrible for it to be cold AND rainy for a few months+1
-
-
-
-
@
SylverReZ:
@cearp, Interesting, considering that the USA has started to legalise cannabis in some states.
-
@
cearp:
Not just "some" - I think it's 24 now that have legalized it for adults, so nearly half!+1
-
-
-
[flush] [walks in without washing my hands] Hi guys 