Hacking PSTV: Henkaku no longer loads and keeps resetting after installing USBMC

[KentaZX]

So I've screwed up apparently when I've tried to move everything from the SD2Vita to a USB flash drive and installed USBMC through the auto plugin II app. Now every time I tried to load up H-encore, The PSTV kept resetting. Is there anyway to fix this or do I basically start over with henkaku at this point?

and If I do have to start over, can I just install the 3.73 update to get rid of the hack? I ask because I'm thinking of using that vita deploy stuff to downgrade to 3.60/3.65 and install enso this time.

 

[godreborn]

do you have your config.txt? I did the opposite, went from usbmc to sd2vita.

 

[KentaZX]

do you have your config.txt? I did the opposite, went from usbmc to sd2vita.

nope it doesnt seem like I do on my usb drive that i copied the ux0 stuff into. And I cant even access vitashell right now to connect with FTP either. because after I open up H-encore and tried to exit, the psTV just resets on its own.

 

[godreborn]

your tai config should be on ur0, but you could put it on ux0 with the changes you've made. usbmc is a kernel exploit, so put that location under KERNEL. you might test it just with that file, but it doesn't sound like ux0 is even being mounted properly, so that may not work.

--------------------- MERGED ---------------------------

hold L at boot to undo any plugins that could be causing the problem, then proceed.

 

[KentaZX]

your tai config should be on ur0, but you could put it on ux0 with the changes you've made. usbmc is a kernel exploit, so put that location under KERNEL. you might test it just with that file, but it doesn't sound like ux0 is even being mounted properly, so that may not work.

--------------------- MERGED ---------------------------

hold L at boot to undo any plugins that could be causing the problem, then proceed.

Okay yea holding L and getting rid of the usbmc plugin fixed my issue and now I got access again. Thank you.