Hi.
I made a Picofly installation today on a V1 patched. I've made 4 or 5 picofly installations before with no problems. I always use the proper flex cable for cpu points, enamel wire for board pads, and a plastic insulated thin awg wire for VCC and GND.
But after installing this one, the console didn't power on, and the chip didn't show any light. The CPU was warm, so something was wrong. I checked everything and realized the GND wire broke just at the GND point of the chip so it wasn't making contact.
After resoldering it and check everything again, I tried to power on and the chip glitched ok and loaded hekate. The problem is that after loading fusee payload for atmosphere (with all files copied to sd), I get the Atmosphere screen, then the "triangle" atmosphere logo, but then, black screen and after some seconds, an orange screen.
If I boot up with both VOL buttons pressed to load OFW and skip the chip, I get the Nintendo logo, but then black screen, and after some time, orange screen.
I saw it may be due to the wifi chip under the Nand board, but I didn't touched that or solder near that chip. Also, Hekate loads, and the info screen shows the MAC Address, so I think that wifi chip must be ok.
I checked every point with a multimeter and everything looks fine with no bridges. I also checked the board with a the big magnifying glass I use for installations, and I can't see any bridges or damage to any trace.
What can be the problem of the menu not loading and displaying an orange screen? I can only think that powering on the switch with that GND point disconnected due to the cable break caused some damage, but I don't know if that can kill a board.
Any help? Thanks a lot!!