Once you get green light, you are golden. Just connect the daughterboard and stick the microSD with the files (boot.dat, payload, etc)Guys how do I align the emmc back? I keep getting it wrong. When i press the power button the mopchip immediately goes green and there is no display. I am using 0.1mm enameled wire for all the points except dat0 gnd and 3.3v. For dat0 im using 0.01mm jumper wire. Is it too thin?
same issue as u, i have checked all points, there are no shorts. all points are with the correct value. can it be the hwfly lite chip?I have install the hwfly chip for the switch oled but the chip will have red light about 3 sec thn ntg happen does any body knw what is the problem?
i use sx lite chipsFor those who were successful in their oled install, did you use hwfly or original sx chips?
Thanks alot! XDYes it is! GND is ALWAYS needed, mate!
You can use any GND spot. Including the ones he mentioned for the Lite.
I've marked some for you...
View attachment 286211
It's really easy to "mess up" when we're too focused on "fixing it"found out the reason why mine is red light!
Guys always double check the wiring, I connected to the yellow one instead of the red for power supply since it looks so similar, cant believe it took me 2 days to find out this mistake.
thanks! yes, i really never suspect the 3.3v pointIt's really easy to "mess up" when we're to focused on "fixing it"
Sometimes we need to take 2 steps back to see the bigger picture!
I'm glad you found the issue!
Way to go, mate!
That's why we measure, there's not too many points.. it's just tougher to make conclusions about data or clock signalsthanks! yes, i really never suspect the 3.3v point
U need to put in ur sd card with the latest hekate/atmosphere fileguys help, I installed everything and the chip blinks then turns green but there is no display…