Good day, i hope its ok to ask my questions here. I have problem using picofly on Nintendo Switch OLED.
Here is short story : same switch with HWFLY is working flawlessly, but with rp2040-Ziro get this error : Faild to init eMMC,
Long Story :
Using picofly Hekate is working ok, but when i try to Launch Stock i get this error : Failed to init eMMC. Failed to launch HOS! press any key...
When i try to Create emuMMC i get this : Your eMMC is initialized in slower mode ! This might mean hardware issues!
When i swap RP-2040 with HWFLY all is working flawlessly - i can run stock and i created emuNAND. I used the same wires for DAT0, CMD, CLK, RST, GND, 3.3v. I only changed the CPU cable. For HWFLY i used the original V3 cable. For RP2040 i used V2 cable with bridge pins 3 and 4 (and i changed it 3 times).
I did change all wires 2 times - nothing worked. Again with HWFLY worked every time.
I add two additional resistors 47omh, one each on CMD and DAT0. Didn't change anything.
Another thing - i am using firmware update fw_2.67.uf2 for RP2040. But when i try to flash the new version fw_2.72.uf2 - the microcontroller flashed yellow. I did bridged the RGB jumper with solder on the rear of the RP2040 - again blinking only yellow. No red light to know the flash was successful.
When i try to run the switch that way (with fw_2.72.uf2) i get purple light in the screen. Hekate dont run.
I do have experience rp2040 but to this day i have installed it only in V1,V2 and Lite. So far everything worked great. First time i am doing it with OLED.
SO i am out of options. I do need help and will be very grateful for every advice.
Thank you in advance.
Here is short story : same switch with HWFLY is working flawlessly, but with rp2040-Ziro get this error : Faild to init eMMC,
Long Story :
Using picofly Hekate is working ok, but when i try to Launch Stock i get this error : Failed to init eMMC. Failed to launch HOS! press any key...
When i try to Create emuMMC i get this : Your eMMC is initialized in slower mode ! This might mean hardware issues!
When i swap RP-2040 with HWFLY all is working flawlessly - i can run stock and i created emuNAND. I used the same wires for DAT0, CMD, CLK, RST, GND, 3.3v. I only changed the CPU cable. For HWFLY i used the original V3 cable. For RP2040 i used V2 cable with bridge pins 3 and 4 (and i changed it 3 times).
I did change all wires 2 times - nothing worked. Again with HWFLY worked every time.
I add two additional resistors 47omh, one each on CMD and DAT0. Didn't change anything.
Another thing - i am using firmware update fw_2.67.uf2 for RP2040. But when i try to flash the new version fw_2.72.uf2 - the microcontroller flashed yellow. I did bridged the RGB jumper with solder on the rear of the RP2040 - again blinking only yellow. No red light to know the flash was successful.
When i try to run the switch that way (with fw_2.72.uf2) i get purple light in the screen. Hekate dont run.
I do have experience rp2040 but to this day i have installed it only in V1,V2 and Lite. So far everything worked great. First time i am doing it with OLED.
SO i am out of options. I do need help and will be very grateful for every advice.
Thank you in advance.