got it to work
some steps are missing in the tuts
when you connect your switch to pegaswitch you have to run:
evalfile usefulscripts/SetupNew.js
inside of pegaswitch terminal not regular terminal
Yeah - It's mentioned briefly on github. I didn't realize it was a mandatory step either. Did you have any issues with ncat providing the switch's IP address?
Before running ace.nro open terminal and type - dont close this.when i'm running "runnro ./nros/ace.nro" my switch gets back at switch system settings and then i run the command "ncat --send-only 192.168.1.6 2991 home/pegaswitch/pegaswitch/nros/retroarch_switch.nro" and terminal says "more than 1 port QUITTING" or something like that
i will try that nowBefore running ace.nro open terminal and type - dont close this.
nc -v -l -p 2991
connect to pegaswitch by check update in any game
runnro /nros/ace.nro
(if it hung system, without error code u fine)
open next terminal then
ncat --send-only 192.168.1.6 2991 < location to your nro
symbol < is important.
Finally got it to work after about 2 hours of resetting switch. Thanks for the instructions @ehnoah !
Again and again, Pegaswitch terminal writes unknown cmd.After I write runnro ./nros/ace.nro Pegaswitch terminal write unknown cmd
you probably have old pegaswitch, without runnro command.Again and again, Pegaswitch terminal writes unknown cmd.
So, how to delete it and copy new one?you probably have old pegaswitch, without runnro command.
im tired and it's hard to explain but I got alot going on i made really dumb mistake and wrote switch ip in my command
Instructions
Load Pegaswitch
Run following in Pegaswitch:
enable sdbcore
evalfile usefulscripts/SetupNew.js
Open 2 cmd promps with Admin rights and enter Bash enter following cmd in one window:
nc -v -l -p 2991
Back to pegaswitch enter:
runnro /nros/ace.nro
Now use the other terminal window. As in video I recommend cd till you are in your nro folder from here enter:
ncat --send-only 192.168.0.2 2991 < retroarch_switch.nro
Replace my ip with yours.
in terminalSo, how to delete it and copy new one?