Will it boot without itMaybe in lite can remove cardreader and plug rp2040 on this place? Sacrifice headphone jack or make some cable.View attachment 358517
Will it boot without itMaybe in lite can remove cardreader and plug rp2040 on this place? Sacrifice headphone jack or make some cable.View attachment 358517
I don't think payload is the problemWould it be possible to swap the payload of rehius firmware with the hwfly firmware? Or is in a different format?
we dont have hwfly fpga fwWould it be possible to swap the payload of rehius firmware with the hwfly firmware? Or is in a different format?
If not removed, can insert it into the card reader itself.Will it boot without it
The Rp2040 in the cardreader slot is a good idea. If the firmware and everything else is working, I can design a new pcb for the Rp2040 IC, so it will fit better and have the boot and reset buttons outside.
But the questions is then, are the cables short enough or do they make problems?
I dont know what the pins of the card reader are but we could use them also, so we dont have to lay new cables around.
Maybe someone can post a schematic of the cars reader slot. Maybe it is also possible to design a housing for the new rp2040 like a normal game cardrigde.
just some possibilitys but need to wait for the working software part.
If not removed, can insert it into the card reader itself.
View attachment 358592
It will stick out a little (if you leave the buttons on the rp2040), but it's better than breaking the case.
View attachment 358593
I have zero need for DragonInjector with AutoRCM and a modded JoyCon but that doesn’t stop me from being very envious every time you post it.
What, what is it? It is some kind of loader that fits in game cards slot?I have zero need for DragonInjector with AutoRCM and a modded JoyCon but that doesn’t stop me from being very envious every time you post it.
It’s an RCM jig and payload injector that fits in a GameCard slot. Nintendo shut it down with a cease and desist. Very few were made and I missed out on all of them.What, what is it? It is some kind of loader that fits in game cards slot?
Really good piece
I think someone is working on it , keep your hopes up ig ?We need firmware more than hardware !
Did you realize what the back plate of the switch is primordial part of the cooling system?, opening that hole will break the console by heat!
I love it
The Soc wire might be to long doing it that way.The Rp2040 in the cardreader slot is a good idea. If the firmware and everything else is working, I can design a new pcb for the Rp2040 IC, so it will fit better and have the boot and reset buttons outside.
But the questions is then, are the cables short enough or do they make problems?
I dont know what the pins of the card reader are but we could use them also, so we dont have to lay new cables around.
Maybe someone can post a schematic of the cars reader slot. Maybe it is also possible to design a housing for the new rp2040 like a normal game cardrigde.
just some possibilitys but need to wait for the working software part.
I think this is just for development phase (which we are right now). In future, he just need order a new backplate and switch back case (they are really cheap in China) for replacement.Did you realize what the back plate of the switch is primordial part of the cooling system?, opening that hole will break the console by heat!
Sacrifices were madeI think this is just for development phase (which we are right now). In future, he just need order a new backplate and switch back case (they are really cheap in China) for replacement.