Hello everyone, I'm reading the forum and I see that the topic with pikofly is not standing still, and now I'm wondering if it makes sense to buy a hwfly chip now, if this topic is growing so fast. But as I understand, picofly cannot launch the official firmware now, and it is not known how long it will take to get all this in order and make it clear to people. because if now not everyone understands how to install a normal chip, then with pikofly, which still needs to be flashed and soldered more... The shorter question is, does it make sense right now to buy pikofly instead of hwfly?
picofly "can launch" official firmware or in other words you can bypass picofly to boot into official firmware, what they're trying is to get custom firmware to launch, there's no point in modding your console to run official firmware
At first I was quite skeptical about pikofly. But now after reading the forum I understand that it is quite interesting and maybe soon it will become possible. The main question will be only how long it will take, because sooner or later it will work out and the chips will cost even cheaper than in 2020. But we have to live until that :/
Hello everyone, I'm reading the forum and I see that the topic with pikofly is not standing still, and now I'm wondering if it makes sense to buy a hwfly chip now, if this topic is growing so fast. But as I understand, picofly cannot launch the official firmware now, and it is not known how long it will take to get all this in order and make it clear to people. because if now not everyone understands how to install a normal chip, then with pikofly, which still needs to be flashed and soldered more... The shorter question is, does it make sense right now to buy pikofly instead of hwfly?
please, never buy things in advance, never before the first stable release. This goes for every single ongoing thing you see on the internet.
Even if your are confident that this project will succeed (I am very confident right now), please don't do it.
The only reason to buy right now is if you want to share some contribution like many are doing here, or if you are extremely curious and don't mind if things go wrong (like me right now).
Well then, thank you very much for your answers. Because I wanted to take hwfly because I didn't expect anything from pikofly, but the fact that hekate and Ubuntu were launched on it confused me quite a bit. Therefore, I had to rely on this topic. Because why spend 75$ if you can spend 3 :/
Now I see that the topic is interesting, but for now it's just a crutch and not a normal release. But it is very interesting, I will have to order a couple of pikofly in case it works out.
Post automatically merged:
In short, thank you very much for the kind of people who develop such an interesting topic.
please, never buy things in advance, never before the first stable release. This goes for every single ongoing thing you see on the internet.
Even if your are confident that this project will succeed (I am very confident right now), please don't do it.
The only reason to buy right now is if you want to share some contribution like many are doing here, or if you are extremely curious and don't mind if things go wrong (like me right now).
Well then, thank you very much for your answers. Because I wanted to take hwfly because I didn't expect anything from pikofly, but the fact that hekate and Ubuntu were launched on it confused me quite a bit. Therefore, I had to rely on this topic. Because why spend 75$ if you can spend 3 :/
Now I see that the topic is interesting, but for now it's just a crutch and not a normal release. But it is very interesting, I will have to order a couple of pikofly in case it works out.
Post automatically merged:
In short, thank you very much for the kind of people who develop such an interesting topic.
genuine question...how did you manage to do this...had you attached a wire and accidently tugged it forcing the pad off...or did it happen during soldering?
genuine question...how did you manage to do this...had you attached a wire and accidently tugged it forcing the pad off...or did it happen during soldering?
I see tinned pads that don't need to be tinned, so right off the bat their tip and solder are probably too large. I don't see flux either, but could have been cleaned off (or no-clean). Pads can usually take a decent tug, as long as you don't overheat them or use too large of wire- I recommend 40AWG for this size of work as it'll almost always be weaker than whatever it's soldered to, so yanking on it will break the wire, not the component or pad.
I see tinned pads that don't need to be tinned, so right off the bat their tip and solder are probably too large. I don't see flux either, but could have been cleaned off (or no-clean). Pads can usually take a decent tug, as long as you don't overheat them or use too large of wire- I recommend 40AWG for this size of work as it'll almost always be weaker than whatever it's soldered to, so yanking on it will break the wire, not the component or pad.
I'm using a grossly oversized tip honestly because I haven't felt like replacing it, but I can 2nd the importance of low-temp solders for things like this.
Good thing solder has flux in it. What on earth type of flux were you using that smells like food? Personally, I use Kingbo RMA-218 BGA flux. Use the syringes, not the jars.
As each year passes, retro games become harder and harder to play, as the physical media begins to fall apart and becomes more difficult and expensive to obtain. The...
While rumors had been floating about rampantly as to the future plans of Nintendo, the President of the company, Shuntaro Furukawa, made a brief statement confirming...
TheFlow has done it again--a new kernel exploit has been released for PlayStation 4 consoles. This latest exploit is called PPPwn, and works on PlayStation 4 systems...
Nintendo might just as well be a law firm more than a videogame company at this point in time, since they have yet again issued their now almost trademarked usual...
Nintendo has officially announced that a successor to the beloved Switch console is on the horizon. As we eagerly anticipate what innovations this new device will...
Another video game prototype has been found and preserved, and this time, it's none other than the game that spawned an entire franchise beloved by many, the very...
DOOM is well-known for being ported to basically every device with some kind of input, and that list now includes the old retro game console in Persona 5 Royal...
Earlier this year, AYANEO revealed details of its next Android-based gaming handheld, the AYANEO Pocket S. However, the actual launch of the device was unknown; that...
With just a couple weeks after its initial release in the App Store, the Delta emulator for iOS was received with great success, after Apple loosened up its rules in...
Retro handheld manufacturer Anbernic has revealed its first clamshell device: the Anbernic RG35XXSP. As the suffix indicates, this handheld's design is inspired by...
Nintendo has officially announced that a successor to the beloved Switch console is on the horizon. As we eagerly anticipate what innovations this new device will...
While rumors had been floating about rampantly as to the future plans of Nintendo, the President of the company, Shuntaro Furukawa, made a brief statement confirming...
As each year passes, retro games become harder and harder to play, as the physical media begins to fall apart and becomes more difficult and expensive to obtain. The...
Nintendo might just as well be a law firm more than a videogame company at this point in time, since they have yet again issued their now almost trademarked usual...
Ubisoft has today officially revealed the next installment in the Assassin's Creed franchise: Assassin's Creed Shadows. This entry is set in late Sengoku-era Japan...
After a little more than three years of exclusivity with the Epic Games Store, Square Enix has decided to bring their beloved Kingdom Hearts franchise to Steam. The...
TheFlow has done it again--a new kernel exploit has been released for PlayStation 4 consoles. This latest exploit is called PPPwn, and works on PlayStation 4 systems...
After rumour got out about an upcoming NES Edition release for the famed Nintendo World Championships, Nintendo has officially unveiled the new game, titled "Nintendo...
DOOM is well-known for being ported to basically every device with some kind of input, and that list now includes the old retro game console in Persona 5 Royal...
The number of layoffs and cuts in the videogame industry sadly continue to grow, with the latest huge layoffs coming from Microsoft, due to what MIcrosoft calls a...