Hacking Question [HELP] Fusee Gelee isn't working

[Ephraim_Bane]

Fusee Gelee isn't working! When I turn on my Switch with my paperclip jig holding power and volume+ it boots to the Switch logo and then turns off. Any ideas?

 

[Purple_Heart]

you sure that your jig is contacting the right pins?

 

[RamTheSecond]

Make sure that you really hit the pins with the paperclip. Otherwise try to use a thin cable that goes from Pin 10 to the metalfan (to properly ground it).

 

[Purple_Heart]

that was pin 7 and 10 if i remember correctly

 

[Ephraim_Bane]

UPDATE: I'm using a piece of a SATA Cable (there's a tutorial on this forum but I'm a new member and can't post links) and I'm sure the pins are shorted correctly. It still isn't working!
I'm holding Vol+ and Power and it boots to the Nintendo logo.

 

[OblivionReign]

Make sure it isn't plugged into anything when you try to enter RCM or it won't work either.

 

[Ephraim_Bane]

It's not. Also nice fake B9S Badge

 

[OblivionReign]

It's not. Also nice fake B9S Badge

Actually it isn't fake it was the first one made for the website but that is okay you will learn eventually young child

 

[Ephraim_Bane]

I've now used a wire, paperclip, and SATA cable pin. My Switch won't boot into RCM at all.

 

[scary_dog]

I've now used a wire, paperclip, and SATA cable pin. My Switch won't boot into RCM at all.

Is it a new switch? If yes then what firmware version did it arrive with?

 

[Ephraim_Bane]

I got it in december, version 4.00.

 

[karloz25]

are you using the correct side of the switch?

 

[Ephraim_Bane]

Yep! I JUST got it into RCM and got the example payload running.

 

[karloz25]

Yep! I JUST got it into RCM and got the example payload running.

what do you have in your SD card?